Ryobi P104 Manuel d'utilisateur télécharger pdf (Page 2)

CAUTION: Charge in a well ventilated area. Do not

block charger vents. Keep them clear to allow proper

ventilation.

BATTERY PROTECTION FEATURES

Ryobi One+ 18 V lithium-ion batteries are designed with

features that protect the lithium-ion cells and maximize

battery life.

If the tool stops during use, release the trigger to reset and

resume operation. If the tool still does not work, the battery

needs to be recharged.

NOTE: The LED charge indicator light will not work if the

battery protection feature has caused the battery pack to

stop powering the tool. When the battery pack resets itself,

the LED will again function.

CHARGING THE BATTERY PACK

Battery packs are shipped in a low charge condition to

prevent possible problems. Therefore, you should charge

them before first use.

If the charger does not charge the battery pack under normal

circumstances, return both the battery pack and charger

to your nearest Authorized Service Center for electrical

check.

TO CHARGE

 Use battery pack only with the recommended charger.

 Connect the charger to the power supply. For a complete list

of approved power sources, refer to the operator’s manual

for the charger.

Make sure the latches on each side of the battery pack snap

into place and the battery pack is secured in the charger

before beginning operation.

 Place the battery pack in the charger aligning raised rib on

the battery pack with the groove in the charger.

 Press down on the battery pack to be sure contacts on the

battery pack engage properly with contacts in the charger.

NOTE: After charging is complete, the green LED will re-

main on until the battery pack is removed from the charger

or charger is disconnected from the power supply.

 The battery pack will become slightly warm to the touch

while charging. This is normal and does not indicate a

problem.

 Do not place the charger and battery pack in an area of

extreme heat or cold. They will work best at normal room

temperature.

NOTE: The charger and battery pack should be placed in

a location where the temperature is more than 50°F but

less than 100°F.

When batteries become fully charged, unplug the charger

from the power supply and remove the battery pack.

To remove the battery pack from the charger, depress the

latches on each side of the battery pack.

SAVE THESE INSTRUCTIONS

987000-146

8-18-10 (REV:06)

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road

Anderson, SC 29625

Phone 1-800-525-2579

www.ryobitools.com

Ryobi® is a registered trademark of Ryobi Limited used under license.

Li - Ion

CHARGING A HOT BATTERY PACK

When using a tool continuously, the batteries in the battery

pack will become hot. You should let a hot battery pack

cool down for approximately 30 minutes before attempting

to recharge.

NOTE: this situation only occurs when continuous use of a

tool causes the batteries to become hot. It does not occur

under normal circumstances. Refer to CHARGING THE

BATTERY PACK for normal recharging of batteries. If the

charger does not charge your battery pack under normal

circumstances, return both the battery pack and charger to

your nearest Authorized Service Center for electrical check.

BATTERIES

These batteries have been designed to provide maximum

trouble-free life. However, like all batteries, they will eventually

wear out. Do not disassemble battery pack and attempt to

replace the batteries. Handling of these batteries, especially

when wearing rings and jewelry, could result in a serious burn.

To obtain the longest possible battery life, we suggest the

following:

 Remove the battery pack from the charger once it is fully

charged and ready for use.

For battery pack storage longer than 30 days:

 Store the battery pack where the temperature is below

80°F and away from moisture.

 Store battery packs in a 30%-50% charged condition.

 Every six months of storage, charge the pack as normal.

BATTERY PACK REMOVAL AND

PREPARATION FOR RECYCLING

To preserve natural resources, please recycle

or dispose of batteries properly.

This product contains lithium-ion batteries.

Local, state or federal laws may prohibit dis-

posal of lithium-ion batteries in ordinary trash.

Consult your local waste authority for informa-

tion regarding available recycling and/or disposal options.

WARNING:

Upon removal, cover the battery pack’s terminals with

heavy-duty adhesive tape. Do not attempt to destroy or

disassemble battery pack or remove any of its compo-

nents. Lithium-ion batteries must be recycled or disposed

of properly. Also, never touch both terminals with metal

objects and/or body parts as short circuit may result.

Keep away from children. Failure to comply with these

warnings could result in fire and/or serious injury.

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Ryobi P104 Manuel d'utilisateur Page 2

Commentaires sur ces manuels