Ryobi YG301PD Manuel d'utilisateur télécharger pdf (Page 12)

12 - English

OPERATION

DRAINING THE TANK

See Figures 7 et 8, page 16.

To help prevent tank corrosion and keep moisture out of the air

used, the air tank of the compressor should be drained daily.

 Turn the air compressor off, as shown in the shut down

section of the quick reference label.

 Pull the ring on the safety valve to release until pressure

gauge reads less than 20 psi, as shown in the shut down

section of the quick reference label.

 Release the ring.

 Rotate drain valves counterclockwise to open, as shown

in the shut down section of the quick reference label.

 Tilt tank to drain moisture from tank into a suitable

container.

NOTE: Condensate is a polluting material and should be

disposed of in compliance with local regulations.

 If drain valve is clogged, release all air pressure, remove

and clean valve, then reinstall.

WARNING:

Unplug the air compressor and release all air from the

tank before servicing. Failure to depressurize tank before

attempting to remove valve can cause serious personal

injury.

 Rotate drain valve clockwise until tightly closed.

CHECKING THE SAFETY VALVE

See Figure 8, page 16.

DANGER:

Do not attempt to tamper with the safety valve. Anything

loosened from this device could fly up and hit you. Failure

to heed this warning could result in death or serious

personal injury.

The safety valve will automatically release air if the air tank

pressure exceeds the preset maximum. The valve should be

checked before each day of use by pulling the ring by hand.

 Turn the air compressor on and allow the tank to fill. The

compressor will shut off when the pressure reaches the

preset maximum.

 Turn the air compressor off.

 Pull the ring on the safety valve to release air for three to

five seconds to allow pressurized air to escape. Release

the ring. The safety release valve must reset and hold

pressure before all compressed air is exhausted from the

tank.

 Any continued loss of air after performing the above steps

indicates a problem with the safety valve. Discontinue

use and seek service before continued use of the air

compressor.

WARNING:

If air leaks after the ring has been released or if the valve is

stuck and cannot be actuated by the ring, do not use the

air compressor until the safety valve has been replaced.

Use of the air compressor in this condition could result

in serious personal injury.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi YG301PD Manuel d'utilisateur Page 12

Commentaires sur ces manuels