Ryobi YG301PD Manuel d'utilisateur télécharger pdf (Page 13)

13 - English

MAINTENANCE

WARNING:

When servicing use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1 during maintenance. If operation

is dusty, also wear a dust mask.

WARNING:

Always release all pressure, disconnect from power

supply, and allow unit to cool to the touch before cleaning

or making repairs on the air compressor.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal injury.

Electric tools used on fiberglass material, wallboard,

spackling compounds, or plaster are subject to

accelerated wear and possible premature failure because

the fiberglass chips and grindings are highly abrasive to

bearings, brushes, commutators, etc. Consequently, we

do not recommend using this product for extended work

on these types of materials. However, if you do work with

any of these materials, it is extremely important to clean

the product using compressed air.

LUBRICATION

All of the bearings in this product are lubricated with a

sufficient amount of high grade lubricant for the life of the

unit under normal operating conditions. Therefore, no further

lubrication is required.

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 15

AFTER SPANISH LANGUAGE SECTION.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Pas de commentaire

Ryobi YG301PD Manuel d'utilisateur Page 13