Ryobi YG601PV1 Manuel d'utilisateur télécharger pdf (Page 14)

14 – English

PROBLEM CAUSE SOLUTION

Compressor will not run Loss of power or overheating

No electrical power

Insufficient power from receptacle

Insufficient power from extension cord

Blown shop/house fuse

Shop/house breaker open

Amperage overload open

Pressure switch bad

Tank is full of air

Check for proper use of extension cord.

Check to be sure unit is plugged in. Check

fuse/breaker.

Use a receptacle on a different circuit.

Refer to chart on page 8 to choose an ap-

propriate extension cord.

Replace shop/house blown fuse.

Reset shop/house breaker, determining why

problem happened.

Move compressor to well-ventilated area.

Unit must be unplugged and allowed to cool

for 30 minutes to initiate reset.

Take compressor to service center.

Compressor will turn on when tank pressure

drops to cut-in pressure.

Motor hums but cannot run or

runs slowly

Low voltage

Wrong gauge wire or length of extension cord

Shorted or open motor winding

Defective check valve

Insufficient power from receptacle

Insufficient power from extension cord

Check with voltmeter.

Check for proper gauge wire and cord length.

Take compressor to service center.

Take compressor to service center.

Use a receptacle on a different circuit.

Refer to chart on page 8 to choose an ap-

propriate extension cord.

Amperage overload protector

cuts out repeatedly

Low voltage

Lack of proper ventilation/room temperature

too high

Wrong gauge wire or length of extension cord

Insufficient power from extension cord

Check with volt meter.

Move compressor to well-ventilated area.

Unit must be unplugged and allowed to cool

for 30 minutes to initiate reset.

Check for proper gauge wire and cord length.

Refer to chart on page 8 to choose an ap-

propriate extension cord.

Air tank pressure drops when

compressor shuts off

Loose connections (fittings, tubing, etc.)

Loose drain valve/open drain valve

Check valve leaking

Check all connections with soap and water

solution and tighten.

Tighten drain valve/close drain valve.

Take compressor to service center.

DANGER:

Do not disassemble check valve, tank

drain valve, or safety valve with air in

tank — bleed tank.

TROUBLESHOOTING

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Commentaires sur ces manuels

Pas de commentaire