Ryobi P128 Manuel d'utilisation et d'entretien télécharger pdf (Page 6)

6 — English

OPERATION

WARNING:

Do not allow familiarity with products to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this product. The

use of attachments or accessories not recommended

can result in serious personal injury.

APPLICATIONS

You may use this tool for the following purpose:

Charging Ryobi 18 Volt lithium-ion or nickel cadmium

batteries

CAUTION:

If at any point during the charging process none of the

LEDs are lit, remove the battery pack from the charger

to avoid damaging the product. DO NOT insert another

battery. Return the charger and battery to your nearest

service center for service or replacement.

CAUTION:

Charge in a well ventilated area. Do not block charger

vents. Keep them clear to allow proper ventilation.

CHARGING

See Figure 2, page 9.

Battery packs are shipped in a low charge condition to

prevent possible problems. Therefore, you should charge

them before first use.

If the charger does not charge your battery pack under

normal circumstances, return both the battery pack and

charger to your nearest repair center for electrical check.

Make sure the power supply is normal household voltage,

120 volts, AC only, 60 Hz.

 Connect the charger to a power supply.

 Attach the battery pack to the charger by aligning the

raised ribs on the battery pack with the grooves in the

charger, and then slide the battery pack onto the charger.

 Press down on the charger to be sure contacts on

the battery pack engage properly with contacts in the

charger. Latches should snap into place to ensure charger

is correctly connected.

 Do not place the charger in an area of extreme heat or

cold. It will work best at normal room temperature.

NOTE: The charger and battery pack should be placed

in a location where the temperature is more than 50°F

but less than 96°F.

 The battery pack may become slightly warm to the

touch while charging. This is normal and does not

indicate a problem.

 After charging is complete, the green LED will remain on

while the charger is in Maintenance mode.

 Charger will periodically wake from Energy Save mode to

ensure the battery pack remains in a fully charged state.

To remove the battery pack from the charger, depress

latches and pull up on the battery pack.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the battery pack may

become hot. A hot battery pack may be placed directly

onto the charger port but charging will not begin until the

battery temperature cools to within acceptable temperature

range. When a hot battery pack is placed on the charger, the

orange LED will begin fading. When the battery pack cools

to approximately 120°F (40°C), the charger will automatically

begin charging.

CHARGING A COLD BATTERY PACK

A cold battery pack may be placed directly onto the charger

port but charging will not begin until the battery temperature

warms to within acceptable temperature range When a cold

battery pack is placed on the charger, the orange LED will

begin fading. When the battery pack warms to approximately

32°F (0°C), the charger will automatically begin charging.

1 2 3 4 5 6 7 8 9 10 11 ... 24 25

Commentaires sur ces manuels

Pas de commentaire

Ryobi P128 Manuel d'utilisation et d'entretien Page 6

Commentaires sur ces manuels