Ryobi P170 Manuel d'utilisation et d'entretien télécharger pdf (Page 2)

BATTERY PROTECTION FEATURES

Lithium-ion battery packs are designed with features that

protect the lithium-ion cells and maximize battery life.

If the tool stops during use, release the trigger to reset and

resume operation. If the tool still does not work, the battery

needs to be recharged.

COLD WEATHER OPERATION

The lithium-ion battery pack can be used in temperatures

down to 32°F (0°C). Put the battery pack on a tool and use

the tool in a light duty application. After about a minute, the

pack will warm up and begin operating normally.

CHARGING THE BATTERY PACK

Battery packs are shipped in a low charge condition to

prevent possible problems. Therefore, you should charge

prior to first use. If the charger does not charge the battery

pack under normal circumstances, return both the battery

pack and charger to your nearest Authorized Service Center

for electrical check.

 Charge the battery pack only with the recommended

charger.

 Connect the charger to a power supply. For approved power

sources, refer to the operator’s manual for the charger.

 Make sure the battery pack is secured in the charger

before beginning operation.

 Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger.

 The battery pack may become slightly warm to the touch

while charging. This is normal and does not indicate a

problem.

 Do not place the charger and battery pack in an area of

extreme heat or cold. They will work best at normal room

temperature.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the battery pack may

become hot. A hot battery pack may be placed directly onto

the charger port but charging will not begin until the battery

temperature cools to within acceptable temperature range.

When a hot battery pack is placed on the charger, the charger

may indicate the pack is not ready to charge. Please refer

to charger operator’s manual. When the battery pack cools,

the charger will automatically begin charging.

CHARGING A COLD BATTERY PACK

A cold battery pack may be placed directly onto the charger

port but charging will not begin until the battery temperature

warms to within acceptable temperature range. When a

cold battery pack is placed on the charger, the charger may

indicate the pack is not ready to charge. Please refer to

charger operator’s manual. When the battery pack warms,

the charger will automatically begin charging.

SAVE THESE INSTRUCTIONS

990000184

7-12-12 (REV:01)

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road

Anderson, SC 29625

A subsidiary of Techtronic Industries Co., Ltd.

OTC: TTNDY

Phone 1-800-525-2579

www.ryobitools.com

RYOBI is a registered trademark of Ryobi Limited and is used pursuant to

a license granted by Ryobi Limited.

MAINTENANCE

BATTERIES

These batteries have been designed to provide maximum

trouble-free life. However, like all batteries, they will

eventually wear out. Do not disassemble battery pack and

attempt to replace the batteries. Handling of these batteries,

especially when wearing rings and jewelry, could result in

a serious burn.

For battery pack storage longer than 30 days:

 Store the battery pack where the temperature is below

80°F and away from moisture.

 Store battery packs in a 30%-50% charged condition.

 Every six months of storage, charge the pack as normal.

BATTERY PACK REMOVAL AND PREPARATION

FOR RECYCLING

To preserve natural resources, please recycle or dispose of

batteries properly.

This product contains lithium-ion batteries.

Local, state or federal laws may prohibit

disposal of lithium-ion batteries in ordinary

trash.

Consult your local waste authority for

information regarding available recycling and/

or disposal options.

WARNING:

Upon removal, cover the battery pack’s terminals with

heavy-duty adhesive tape. Do not attempt to destroy

or disassemble battery pack or remove any of its

components. Batteries must be recycled or disposed

of properly. Also, never touch both terminals with metal

objects and/or body parts as short circuit may result.

Keep away from children. Failure to comply with these

warnings could result in fire and/or serious injury.

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Ryobi P170 Manuel d'utilisation et d'entretien Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Chargeurs de batterie Ryobi P170