Ryobi 232RD Manuel de l'opérateur télécharger pdf (Page 20)

20 – English

ASSEMBLY

Assembling the spray guard and

trimmer head Trimmy SII (235R)

• Fit the guard (A) intended

for use with the trimmer

head. Secure using four

bolts (L) and the support

plate (M) as shown in the

diagram.

• Fit the driver plate (B) on

the drive shaft.

• Rotate the drive shaft so

that one of the holes in the

driver plate lines up with

the corresponding hole in

the gear housing.

• Insert the locking pin (C)

into the hole to lock the

shaft.

• Screw on the trimmer

head (H) in the opposite

direction to the normal

direction of rotation.

• Tighten the trimmer head

to a torque of 35-50 Nm

(3.5-5 kpm).

• To remove the trimmer

head just reverse the

sequence.

Assembling the spray guard and

trimmer head Superauto II

(225R/RD, 227R/RD, 232R/RD)

• Fit the guard (A) intended

for use with the trimmer

head. Secure using the 4

bolts (L) and the support

plate (M) as set out in the

diagram.

• Fit the drive disc (B) on the

output axle.

• Turn the blade axle until

one of the holes in the

drive disc aligns with the

hole in the gear housing.

• Insert the locking pin (C)

in the hole so that the axle

is locked.

• The trimmer head must be

split to be fitted (see the

diagram). Proceed as

follows:

• Insert your finger into the

centre hole of the cover (I)

at the same time as you

hold the cover with your

other fingers. Press the two

catches (J) that extend from

the cut-out on the bottom

section (K) using the

thumb and index finger of

your other hand. Press

apart the trimmer head

using the fingers on the

cover.

• Place the cover (I) and the

support flange (F) on the

output axle.

• Fit the nut (G). The

tightening torque of the

nut is 35-50 Nm (3,5-5

kpm). Use the socket

spanner in the tool kit.

Hold the handle of the

spanner as close to the trimmer guard as possible. The nut is

tightened when the spanner is turned against the direction of

rotation (left-hand thread).

• Fit the trimmer head‘s bottom section (K) on the cover (I)

by pressing the two sections together with the cut-outs on

the bottom section aligned with the catches on the cover.

• To dismantle follow the instructions in the reverse order.

• Fit the guard (A)

intended for use with

the trimmer head.

Secure using four bolts

(L) and the support plate

(M) as shown in the

diagram.

• Fit the disc drive (B) on

the output axle.

• Turn the blade axle until

one of the disc drive’s

holes aligns with the

corresponding hole in

the gear housing.

• Insert the locking pin

the axle.

• Screw on the trimmer

head (H) in the

direction of rotation.

• Dismantling takes place

in the reverse order.

Assembling other guards and

cutting equipment

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Ryobi 232RD Manuel de l'opérateur Page 20

Commentaires sur ces manuels