Ryobi 3000 PSI Manuel d'utilisateur télécharger pdf (Page 11)

ASSEMBLY

ADDING OIL TO THE ENGINE

See Figure 7.

NOTE: This machine has been shipped with approximately

2 oz. of oil in the enginge from testing. You must add oil to

the engine before starting it the first time.

CAUTION:

Any attempt to start the engine without adding oil will

result in engine failure.

n Place pressure washer on a flat, level surface.

n Unscrew the oil cap / dipstick by turning counterclock-

wise.

n Using 4-stroke engine oil (10W-30), fill to the upper level of

the oil filter neck (18 oz., 4-cycle engine oil provided).

n Replace the oil cap / dipstick and securely tighten.

NOTE: This engine has an oil capacity of 20 oz. (or .6

liters).

ADDING GASOLINE TO THE FUEL TANK

See Figure 8.

WARNING:

Gasoline and its vapors are highly flammable and

explosive. To prevent serious personal injury and prop-

erty damage, handle gasoline with care. Keep away from

ignition sources, handle outdoors only, do not smoke

while adding fuel, and wipe up spills immediately.

When adding gas to the pressure washer, make sure the unit

is sitting on a flat, level surface and that the engine is not

hot. If the engine is hot, let the pressure washer cool before

adding gas. ALWAYS fill the fuel tank outdoors.

n Make sure the ON/OFF switch is in the OFF ( O )

position.

n Close the fuel valve before filling the fuel tank.

n Before removing the fuel cap, clean the area around it.

Remove the fuel cap.

n Insert a clean funnel into the fuel tank.

n Slowly pour gasoline into the fuel tank (always use the fuel

filter screen when filling the fuel tank). Wipe any spilled

fuel off the machine before starting.

NOTE: Do not fill above the top of the fuel filter screen

or the gas may overflow when it heats up later and

expands.

n Replace fuel cap and securely tighten.

n Clean up any spills before starting the engine.

Fig. 8

Fig. 7

FUEL

CAP

FUNNEL

OIL CAP / DIPSTICK

UPPER LEVEL OF

OIL FILTER NECK

Fig. 6

CLEAR

INJECTION

HOSE

BARBED

FITTING

SLOT

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Ryobi 3000 PSI Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Carwash Ryobi 3000 PSI