Ryobi 3000 PSI Manuel d'utilisateur télécharger pdf (Page 23)

23

I. MAINTENANCE STATEMENTS

It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2002

and later Owner’s Manual and to retain proof that inspection and maintenance services are performed at the times when recom-

mended. FUJI will not deny a warranty claim solely because you have no record of maintenance; however, FUJI may deny a warranty

claim if your failure to perform required maintenance resulted in the failure of warranted part. The proof which you maintain should

be given to each subsequent owner of the engine. You are responsible for performing the scheduled maintenance described below

based on the procedures specified in the 2002 and later Owner’s Manual. The scheduled maintenance below is based on a normal

engine operating schedule.

PROCEDURE INTERVAL

1) Clean engine and check bolts & nuts: Every 8 hours (daily)

2) Check and refill engine oil: Every 8 hours (refill daily up to upper limit)

3) Change engine oil: Initial 20 hours and every 100 hours afterward

4) Clean spark plug: Every 50 hours (weekly)

5) Clean air cleaner: Every 50 hours (weekly)

6) Replace air cleaner element: Every 200 hours (monthly)

7) Clean fuel filter: Every 200 hours (monthly)

8) Clean and adjust spark plug and electrodes: Every 200 hours (monthly)

9) Replace spark plug: Every 500 hours

10) Remove carbon from cylinder head: Every 500 hours

11) Check and adjust valve clearance: Every 500 hours

12) Clean and adjust carburetor: Every 500 hours

13) Replace fuel lines: Every 1000 hours (yearly)

14) Overhaul engine: Every 1000 hours

NOTE: More frequent maintenance may be necessary under dusty, dirty or severe conditions.

WARRANTY

When warranty repair is needed, the engine must be brought to an

authorized service dealer or warranty station’s place of business

during normal business hours. In all cases, a reasonable time,

not to exceed 30 days, must be allowed for the warranty repair

to be completed after the engine is received by the authorized

service dealer or warranty station.

G. MAINTENANCE, REPLACEMENT AND REPAIR OF

EMISSION-RELATED PARTS

Only warranted engine replacement parts approved by FUJI should

be used in the performance of any warranty maintenance or repairs

on emission-related parts. If other than authorized parts are used

for maintenance, replacement or repair of components affecting

emission control, you should assure yourself that such parts are

warranted by their manufacturer to be equivalent to authorized

parts in performance and durability. FUJI, however, assumes

no liability under this warranty with respect to parts other than

authorized parts. The use of non-authorized replacement parts

does not invalidate the warranty on other components unless the

non-authorized parts cause damage to warranted parts.

H. PARTS COVERED UNDER THE CALIFORNIA EMISSIONS

WARRANTY

(1) Fuel Metering System

(i) Carburetor and internal parts (and/or pressure regulator or

fuel injection system).

(ii) Air/fuel ratio feedback and control system, if applicable.

(iii) Cold start enrichment system, if applicable.

(iv) Regulator assembly (gaseous fuel, if applicable).

(2) Air Induction System

(i) Intake manifold, if applicable.

(ii) Air filter

(3) Ignition System

(i) Spark plugs.

(ii) Magneto or electronic ignition system.

(iii) Spark advance/retard system, if applicable.

(4) Exhaust manifold, if applicable.

(5) Miscellaneous Items Used in Above Systems

(i) Electronic controls, if applicable.

(ii) Hoses, belts, connectors, and assemblies.

(iii) Filter lock assembly (gaseous fuel, if applicable).

Ryobi 3000 PSI Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Ryobi 3000 PSI Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Carwash Ryobi 3000 PSI