Ryobi RY80533 Manuel d'utilisateur télécharger pdf

ABRASIVE GENTLE

991000240

10-21-14 (REV:01)

WARNING:

This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to

the operator’s manual.

FIRST TIME ASSEMBLY

RY80533 QUICK REFERENCE GUIDE

STARTING THE UNIT (COLD START) USING DETERGENT

Install the handle (see page 8).

Add entire bottle of oil provided to the pressure

washer (see page 10).

Completely uncoil garden hose or remove

completely from reel to prevent kinks.

Turn water faucet on fully.

Make sure there are no leaks.

With no nozzle installed, squeeze the trigger

to relieve air pressure. Hold the trigger until a

steady stream of water appears.

Add fuel (see page 10).

Move choke lever to START position

(see page 11).

Pull starter grip and rope to start (see page 10).

Move the fuel valve to OPEN (see page 11).

Put on/off switch in ON position (see page 11).

Allow engine to run for several seconds, then move

choke lever to RUN position (see page 11).

NOZZLE SELECTION GUIDE

Use of soap nozzle will activate detergent injector at a 20:1

dilution ratio.

WARNING! Never use bleach or solvent-based detergent.

• Will damage your pump

• Will void your warranty

• Will damage plants/shrubs

BEFORE STORING THE UNIT

Always add Pump Protector to the unit after each use and before storing. This will significantly

improve pump life. (See page 14)

Pump Protector is available from your local retailer. For further assistance, call customer service

at 1-800-860-4050.

To add, follow the instructions provided by the Pump Protector manufacturer.

Use the chart below to determine the correct nozzle for your job.

HIGH PRESSURE

(NO SOAP WHEN USING THESE NOZZLES)

LOW

PRESSURE

(FOR SOAP OR

GENTLE RINSE)

0º Red

25º Green 40º White

Blue Soap

Nozzle

Concrete, Brick, Masonry

   

Siding, Gutters, House

  

Fencing, Deck, Patio

  

Lawn Equipment, Boat, RV

  

 Recommended Nozzle  Use With Caution for Certain Applications

Turn the fuel valve to OFF before adding oil.

Set unit on flat surface so engine is level.

Remove dipstick, wipe clean, put back in hole

(but don’t screw in) and check oil level.

This is a 4-cycle engine. Do not mix fuel and

oil together.

Add fuel stabilizer every time you fuel the

machine.

RESTARTING THE UNIT

(HOT RESTART)

If the engine does not start:

• check for enough fuel;

• may need to adjust choke position;

• try starting again.

PUMP

PROTECTOR

Connect the high pressure hose to the trigger

handle (see page 8).

Connect your garden hose to the pressure washer

(see page 9).

ON/OFF

SWITCH (ON)

CHOKE LEVER

(RUN)

DO NOT OVERTILT THE UNIT!

Pull starter grip and rope to start (see page 11).

Install blue soap nozzle

(see page 12).

If detergent injection hose comes loose from pressure

washer, reattach it here.

Pour pressure washer

detergent in detergent tank

(see page 13).

Squeeze trigger and wait

approx. 5 seconds for soap

(see page 13).

5 S

Connect the spray wand to the trigger handle

(see page 8).

Connect the high pressure hose to the pump

(see page 8).

Completely uncoil and straighten high pressure

hose to prevent kinks.

FUEL VALVE

(OPEN)

5 S

Make the most of your purchase! Go to www.ryobitools.com and

maintaining your product, please call, 1-800-860-4050.

NOTICE:

Do not use E15 or E85 fuel (or fuel con-

taining greater than 10% ethanol) in this

product. It is a violation of federal law

and will damage the unit and void your

warranty.

CHOKE LEVER

(START)

DETERGENT

RY80533 QUICK REFERENCE GUIDE 1

Résumé du contenu

Page 1 - RY80533 QUICK REFERENCE GUIDE

ABRASIVE GENTLE991000240 10-21-14 (REV:01)WARNING:This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk