Ryobi RY80930 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Carwash Ryobi RY80930. Ryobi RY80930 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
ABRASIVE GENTLE
990000744
11-25-13 (REV:01)
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to
the operator’s manual.
fIRst tIme Assembly
Ry80930 seRIes QuIck RefeReNce GuIde
stARtING the uNIt (cold stARt) usING deteRGeNt
1
Install the handle (see page 8).
Add entire bottle of oil provided to the pressure
washer (see page 10).
6
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until a
steady stream of water appears.
Add fuel (see page 10).
1
2
Pull choke lever all the way out to START
(see page 11).
3
Pull recoil starter to start (see page 11).
5
Turn the fuel valve to OPEN (see page 11).
Put on/off switch in ON position (see page 11).
4
Allow engine to run for several seconds, then move
choke to OFF (RUN) position (see page 11).
Nozzle selectIoN GuIde
Use of soap nozzle will activate detergent injector at a 20:1
dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
Will damage your pump
Will void your warranty
Will damage plants/shrubs
befoRe stoRING the uNIt
Add Pump Protector to the unit after each use and before storing. This will significantly improve pump
life.
To order Pump Protector, call customer service at 1-800-242-4672.
To add, follow the instructions provided by the Pump Protector manufacturer. (See page 15)
1
Use the chart below to determine the correct nozzle for your job.
HIGH PRESSURE
(NO SOAP WHEN USING THESE NOZZLES)
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
0º Red
25º Green 40º White
Blue Soap
Nozzle
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
Recommended Nozzle Use With Caution for Certain Applications
Turn the fuel valve to OFF before adding oil.
Set unit on flat surface so engine is level.
Remove dipstick, wipe clean, put back in hole
(but don’t screw in) and check oil level.
This is a 4-cycle engine. Do not mix fuel and
oil together.
Add fuel stabilizer every time you fuel the
machine.
DO NOT USE E15 OR E85 FUEL IN THIS UNIT.
IT IS A VIOLATION OF FEDERAL LAW AND WILL
DAMAGE THE UNIT AND VOID YOUR WARRANTY.
RestARtING the uNIt
(hot RestARt)
6
If the engine does not start:
check for enough fuel;
may need to adjust choke position;
try starting again.
PUMP
PROTECTOR
Connect the high pressure hose to the trigger
handle (see page 8).
3
Connect your garden hose to the pressure washer
(see page 9).
5
CHOKE LEVER
ON (START)
ON/OFF
SWITCH ON
CHOKE LEVER
OFF (RUN)
do Not oveRtIlt the uNIt!
Pull recoil starter to start (see page 11).
1
2
Install blue soap nozzle
(see page 12).
25
If detergent injection
hose comes loose
from pressure washer,
reattach it here.
1
Pour pressure washer
detergent in detergent tank
(see page 13).
3
Squeeze trigger and wait
approx. 5 seconds for soap
(see page 13).
5 S
Assemble the trigger handle (see page 8).
2
Connect the high pressure hose to the pump
(see page 8).
4
Completely uncoil and straighten high pressure
hose to prevent kinks.
OPEN
CLOSE
ON
FUEL VALVE OPEN
5 S
If you need more assistance,
visit our website at www.ryobitools.com
or call us at 1-800-860-4050.
Vue de la page 0
1

Résumé du contenu

Page 1 - If you need more assistance

ABRASIVE GENTLE99000074411-25-13 (REV:01)WARNING:This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk

Modèles reliés RY802800 | RY80544 | RY80533 |

Commentaires sur ces manuels

Pas de commentaire