Ryobi TC401 Manuel d'utilisation et d'entretien Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8 — English
FEATURES
PRODUCT SPECIFICATIONS
Wheel Diameter (Included) ........................................... 4 in.
Wheel Diameter (Max Capacity) .............................4-3/8 in.
Cutting wheel Arbor .................................................. 5/8 in.
Cutting Depth at 0º ............................................... 1-5/32 in.
Cutting Depth at 45º .................................................. 3/4 in.
No Load Speed ...................................13,700 r/min. (RPM)
Wheel Type ......................Continuous Rim Diamond Wheel
Input ................................. 120 V, AC only, 60 Hz, 12 Amps
KNOW YOUR TILE SAW
See Figure 3, page 15.
The safe use of this product requires an understanding of
the information on the product and in this operator’s manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all
operating features and safety rules.
BEVEL ADJUSTMENT
The bevel adjustment feature allows you to make bevel cuts
up to 45º.
CONTINUOUS RIM DIAMOND WHEEL
The continuous rim diamond wheel provided with this saw
is for wet cutting only. Dry cutting is possible with the use
of an optional cutting wheel marked as usable for dry cut-
ting (not included). This tile saw will accept either a 4” or a
4-3/8” (111 mm) continuous rim cutting wheel.
ELECTRICAL
POSITION OF THE TILE SAW
See Figure 2, page 15.
To avoid the possibility of the tool plug or outlet getting
wet, position tile saw to one side of a wall-mounted outlet
to prevent water from dripping onto the outlet or plug. The
operator should arrange a “drip loop” in the cord connecting
the saw to the outlet. The “drip loop” is that part of the cord
below the level of the outlet, or the connector if an extension
cord is used, to prevent water traveling along the cord and
coming in contact with the outlet.
If the plug or outlet does get wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that supplies power
to the tool then unplug and examine for the presence of
water in the outlet.
WARNING:
To reduce the risk of electrocution, keep all connections
dry and off the ground. Do not touch the plug with wet
hands.
DEPTH ADJUSTMENT
Change the depth of cut from 0 to 1-5/32 in. using the depth
adjustment knob.
ERGONOMIC DESIGN
The design provides comfort when operating in different
positions and at different angles.
GFCI PLUG
The saw is equipped with a GFCI plug to guard against the
hazards of ground fault currents. This plug does not protect
against short circuits, overloads, or shocks.
LOCK-ON BUTTON
The lock-on button is convenient for continuous use for
extended periods of time.
WATER SUPPLY KIT
For wet tile cutting, install the water supply kit and connect
to an appropriate water supply.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Commentaires sur ces manuels

Pas de commentaire