Ryobi 170r Manuel d'utilisateur télécharger pdf (Page 7)

ASSEMBLY INSTRUCTIONS (Continued)

WARNING

To avoid serious personai injury, unplug the unit

before assembling vacuum components.

1. Release the vacuum door by very carefully inserting a

flat head screwdriver into the latch opening (Fig. 3).

Twist the tip of the screwdriver gently and pull open the

door with your other hand (Figs. 3 and 4).

Align the arrow on the upper tube with the arrow on the

motor housing (Fig. 5). Note that the flat on the upper

tube faces the vacuum door as you install the tube.

Slide the upper tube into the motor housing. Turn the

tube clockwise until the dot on the tube aligns with the

dot on the motor housing (Fig. 6).

WARNING

Vacuum tube assembly must be used whenever

the door is open to avoid contact with rotating

blades.

4. Slide the lower vac tube into the upper vac tube. The

arrow on the lower tube should align with the arrow on

the upper tube (Fig, 7).

5. Turn the tube clockwise until the dot on the lower tube

aligns with the dot on the upper tube.

NOTE: For electric vacuum kits, the shorter end

of the vacuum bag elbow tube with the

raised ribs should be inserted through the

zipper opening. See Fig. 8.

6. Open the zipper on the large end of the vacuum bag.

7. Insert the vacuum elbow tube through the zipper

opening in the vacuum bag (Fig. 8), then through bag

opening in the other end of the bag until the bag tube

opening is seated against the tube flange.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Ryobi 170r Manuel d'utilisateur Page 7