Ryobi 310r Manuel d'utilisateur télécharger pdf (Page 9)

WARNING

Remove fuel cap slowly to avoid injury

from fuel spray.

NOTE: BE SURE TO READ THESE

INSTRUCTIONS CAREFULLY BEFORE

ATTEMPTING TO START OR OPERATE

THIS UNIT. Using old or improper oil or

fuel, or improperly mixing the oil and fuel

can cause engine damage. This type of

damage will void the engine warranty.

WARNING

Gasoline is extremely flammable and its

vapors can explode if they are ignited. Always

stop the engine and allow it to cool before filling

the fuel tank. Do not smoke while filling the

tank. Keep sparks and open flames away from

the area.

RECOMMENDED OIL TYPE

A 4 oz. (0.118 liter) bottle of 2-cycle engine oil is included

with your product.

RYOBI 2-cycle oil is recommended for this outdoor power

tool. If another brand of 2-cycle oil is used, make sure it is

high quality oil, formulated for 2-cycle, air-cooled engines.

DANGER: Combustible mixture contains petroleum

distillate. Store away from heat or open flame.

Harmful or fatal if swallowed. If swallowed, do

not induce vomiting. CALL PHYSICIAN

IMMEDIATELY. Avoid prolonged contact with

skin. Wash thoroughly after handling.

Do not reuse bottle.

RECOMMENDED FUEL TYPE

Use clean, fresh, unleaded gasoline that is less than 60

days old.

NOTE: Alcohol blended fuel absorbs moisture

(water). As little as 1% moisture in the

fuel can cause fuel and oil to separate

and form acids when stored.

If this type of fuel must be used, use

fresh fuel, (less than 60 days old) and

mix according to the mixing instructions.

DEFINITION OF BLENDED FUELS

Today's fuels are often a blend of gasoline and one or

more oxygenates such as ethanol, methanol or MTBE

(ether).

OIL & FUEL INFORMATION

THIS ENGINE IS CERTIFIED TO OPERATE ON UNLEADED GAS AND OIL MIXTURE.

USE OF BLENDED FUELS

If you choose to use a blended fuel or its use is unavoid-

able, the following precautions are recommended.

1. Always use fresh fuel mix per your operator's manual.

2. Use the special additive STA-BIL

or an equivalent.

3. Always agitate the fuel mix before fueling the unit.

4. Drain the tank and run the engine dry before storing

the unit.

USE OF FUEL ADDITIVES

The use of fuel additive, such as STA-BIL

Gas Stabilizer

or an equivalent, will inhibit corrosion and minimize the

formation of gum deposit. Add 0.8 oz (23 ml) per gallon of

fuel per instructions on container. NEVER add fuel addi-

tives directly to the unit's fuel tank. Using a fuel additive

can keep fuel fresh for up to six (6) months.

OIL AND FUEL MIXING INSTRUCTIONS

NOTE: For proper engine operation and maxi-

mum reliability, pay strict attention to the

oil and fuel mixing instructions on the

2-cycle oil container. Use a 32:1 fuel/oil

ratio when you use 2-cycle oil. Using

improperly mixed fuel can severely dam-

age the engine.

Thoroughly mix the proper ratio of 2-cycle engine oil with

unleaded gasoline in a separate fuel can, 32:1. Do not mix

them directly in the engine fuel tank. See the table below

for specific gas and oil mixing ratios.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi 310r Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ryobi 310r