Ryobi RY42110 Manuel d'utilisateur télécharger pdf (Page 11)

9 - English

STARTING AND STOPPING

See Figure 7.

NOTE: For added safety, your blower/vac has double safety

switching. If the blower/vacuum tube is not properly con-

nected to the motor housing or the tubes are not fully ex-

tended and have not locked in place, the blower/vac will not

start. Check the troubleshooting guide later in this manual

for more information.

To start the blower/vac:



Attach the outlet end of an extension cord to the plug on

the cord at the rear of blower vac.

NOTE: Use only an approved outdoor extension cord as

described previously in this manual.



Route the extension cord through the side of the loop

located on the rear of the blower housing and place

underneath the cord retainer.

CAUTION:

Always secure extension cord to unit by using cord re-

tainer. Failure to use cord retainer may result in damage

to the unit and/or extension cord.



Connect the blower/vac to the power supply. The live tool

indicator will glow blue once the blower/vac is connected

to the electric power supply.



Pull the trigger to start the blower/vac.

To stop the blower/vac:



Release the trigger.

VARIABLE SPEED CONTROL

See Figure 8.

You can adjust the speed of the unit by turning the

variable speed control clockwise to increase speed or

counterclockwise to decrease speed.

WARNING:

Never run the unit without the vacuum tube and vacuum

bag installed. Use of an improperly assembled unit could

result in serious personal injury.

OPERATING THE BLOWER

See Figure 9.

 To keep from scattering debris, blow around the outer

edges of a debris pile. Never blow directly into the center

of a pile.

 To reduce sound levels, limit the number of pieces of

equipment used at any one time.

 Use rakes and brooms to loosen debris before blowing.

In dusty conditions, slightly dampen surfaces when water

is available.

OPERATION

WARNING:

Do not allow familiarity with this product to make you

careless. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1, along with hearing protection.

Failure to do so could result in objects being thrown into

your eyes and other possible serious injuries.

WARNING:

Never remove discharge outlet elbow. Removal of elbow

could result in contact with moving fan blades and cause

serious personal injuries.

APPLICATIONS

You may use this product for the purposes listed below:



Clearing leaves and other debris from your lawn



Keeping decks and driveways free from leaves and pine

needles



Vacuuming leaves from your lawn

SWITCHING BETWEEN BLOWER MODE AND

VACUUM MODE

See Figure 6.

WARNING:

Always ensure that your unit is switched off and has fully

stopped before changing the mode of operation. Do not

force the quick change lever. It should move smoothly

without resistance. If you encounter problems, discon-

nect from power supply and clean the lever mechanism.

For blower mode:



Switch the quick change lever DOWN so it points to the

blow symbol ( ).

For vacuum mode:



Switch the quick change lever UP so it points to the

vacuum symbol ( ).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY42110 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ryobi RY42110