Ryobi ESR2400A Manuel d'instructions télécharger pdf (Page 8)

English

- 7 -

After use, unplug the shredder and clean it inside and out.

All un-painted metal parts should be greased to prevent

rusting.

When closing the shredder take care to remove all dirt and

debris from the thread of the hole of the securing knob for

the cover.

If the cover is not closed properly, the shredder will not start.

Take care not to cross-thread the bolt when the cover is

being bolted down.

If shredding is not coming out of the chute, stop and unplug

the shredder, remove the lid and clear the chute.

CARE & MAINTENANCE

If the machine is overloaded, an overload protection

switch will cut the shredder off-leave it for about 5

minutes and try again it should then start.

(See Fig. 6)

Place the collecting bag, a bucket or small bin under the

chute to collect the shredding in.

Do not put your hand inside the hopper, when necessory

use the plunger.

Do not try to force branches in that are too large for the

machine.

The blades tend to pull the branches into the shredder

but finer material such as leaves may need to be pushed

through with the plunger.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Ryobi ESR2400A Manuel d'instructions Page 8