Ryobi 2075RC Manuel de l'opérateur télécharger pdf (Page 10)

OPERATING INSTRUCTIONS

CAUTION:

Do not remove or alter

the line cutting blade assembly.

Excessive line length will cause

clutch to overheat and may result

in serious personal injury.

Fig. 9

Each time the head is bumped, about 1 inch

(25.4 mm) of trimming line is released. A blade

in the string guard will cut the line to the proper

length if excess line is released.

For best results, tap the head on bare ground

or hard soil. If line release is attempted in tall

grass, the engine may stall.

Fig. 8

ADJUSTING TRIMMING LINE LENGTH

Your unit is equipped with a cutting head that

allows the operator to release more trimming

line without stopping the engine. To release

additional line, lightly tap the cutting head on

the ground (Fig. 8) while operating the unit at

high speed.

NOTE: Always keep the trimming line fully

extended. Line release becomes more

difficult as cutting line becomes shorter.

DECORATIVE TRIMMING

Decorative trimming is accomplished by

removing all vegetation around trees, posts,

fences, etc.

Rotate the entire unit so that the cutting head

is at a 30° angle to the ground (

Fig. 9

MAINTENANCE AND REPAIR INSTRUCTIONS

FREQUENCY MAINTENANCE REQUIRED REFER TO:

Daily or Before Fill fuel tank with correct oil and fuel mixture. Page 8

Starting Engine

Every 10 Hours Clean and re-oil air filter. Pages 13-14

Every 50 Hours Check spark plug condition and gap. Page 15

MAINTENANCE SCHEDULE

These required maintenance procedures

should be performed at the frequency stated

in the table. They should also be included as

part of any seasonal tune-up.

WARNING: Never perform maintenance

or repairs with unit running. Always

perform maintenance and repairs on a

cool unit. Disconnect spark plug wire to

make sure the unit will not start.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi 2075RC Manuel de l'opérateur Page 10

Commentaires sur ces manuels