Ryobi TBBC Manuel de l'opérateur télécharger pdf (Page 14)

MAINTENANCE AND REPAIR INSTRUCTIONS

CLEANING

Use a small brush to clean off the outside of the unit. Do

not use strong detergents. Household cleaners that

contain aromatic oils such as pine and lemon, and

solvents such as kerosene, can damage plastic housing

or handle. Wipe off any moisture with a soft cloth.

STORAGE

• Store the unit locked up to prevent unauthorized use or

damage.

• Store the unit in a dry, well-ventilated area.

• Store the unit out of the reach of children.

To avoid serious

personal injury,

always turn your unit off and allow it to cool

before you clean or service it.

WARNING:

Fig. 18

6. Remove the locking rod from the locking rod slot.

1/4-1/2 turn

Counterclockwise

3. Align the shaft bushing hole with the locking rod

slot and insert the locking rod into the bushing hole

(Fig. 14).

4. Put the blade retainer and nut on the output shaft.

Make sure that the blade is installed correctly.

5. Tighten nut counterclockwise against the blade while

holding the locking rod:

• If using a torque wrench and an 13 mm socket tighten

to: 325 - 335 in•lb, 27 - 28 ft.•lb, 37 - 38 N•m.

• Without a torque wrench, use a 13 mm closed-end or

socket wrench, turning the nut until the blade retainer

is snug against the shaft bushing. Make sure that the

blade is installed correctly, then rotate the nut an

additional 1/4 to 1/2 turn counterclockwise (Fig. 18).

Do not sharpen the

cutting blade.

Sharpening the blade can cause the blade tip

to break off while in use. This can result in

severe personal injury. Replace the blade.

WARNING:

To avoid serious

personal injury or

damage to the unit, do not start or operate this

unit with the locking rod in the locking rod slot.

WARNING:

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi TBBC Manuel de l'opérateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Outils de jardin Ryobi TBBC