Ryobi 770rEB Manuel d'utilisateur télécharger pdf (Page 9)

ASSEMBLY INSTRUCTIONS

7. Tighten the clamp screws evenly, until the J-handle

is secure.

6. While holding the unit in the operating position

(Fig. 3), position the J-handle to the location

that provides you the best grip.

Decal

INSTALLING AND ADJUSTING THE J-HANDLE

1. Place the J-handle between the top and middle

clamp pieces (Fig. 1).

(4) Screws

Top Clamp

J-Handle

Middle Clamp

Bottom Clamp

Nuts

2. While holding the three pieces together, install the

four (4) screws through the top clamp and into

middle clamp.

NOTE: The holes in the top and middle clamp will line up

only when assembled correctly.

3. Place the clamps and J-handle the over the shaft

housing and onto the bottom clamp.

4. Hold each hex nut in the bottom clamp recess with a

finger. Start screws with a large Phillips screwdriver.

Do not tighten until you make the handle adjustment.

5. Slide the J-handle in or out until the arrow/white line

on the decal touches the clamp assembly (Fig. 2).

Fig. 1

Fig. 2

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Pas de commentaire

Ryobi 770rEB Manuel d'utilisateur Page 9