Ryobi 775r Manuel d'utilisateur télécharger pdf (Page 18)

MAINTENANCE AND REPAIR INSTRUCTIONS

Bump Knob

Foam Seal

Spring

Inner Reel

Installing a Prewound Inner reel

1. Remove the bump knob, spring, and foam

seal by turning the Bump Knob

counterclockwise (Fig. 26).

9. If winding the line becomes difficult or the

line jams, pull the ends of the line from the

spool (Fig. 25). Continue winding the inner

reel counterclockwise .

4. Hold the inner reel in place and install the

bump knob, spring and foam seal by

pressing down and turning the bump knob

clockwise. Grasp the ends and pull firmly to

release the line from the holding slots in the

inner reel. (Fig. 25).

Releasing the Inner Reel

If the SpeedSpool

does not release line

correctly, pull the ends of the line firmly from

the spool (Fig. 25). If this does not release line,

follow the Cleaning the SpeedSpool

instructions below.

Cleaning the SpeedSpool

may be necessary,

• To remove jammed or excess line,

• If the SpeedSpool

becomes difficult to wind

or does not operate correctly when bumping

the head on the ground,

1. Hold the outer spool, and unscrew the bump

knob counterclockwise (Fig. 28).

2. Pull out the bump knob, spring, and foam

seal (Fig. 26).

Fig. 28

Fig. 27

Fig. 25

Fig. 24

Fig. 26

2. Pull the old inner reel with existing line from

the outer spool.

8. Hold the outer spool. Wind the inner reel

counterclockwise until approximately four (4)

inches (102 mm.) of line remain (Fig. 24).

NOTE: Do not wind the inner reel before

installing the second piece of line.

3. Insert the ends the of line into the outer

spool eyelets (Fig. 27). Push the new inner

reel, arrow side up, into the outer spool.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi 775r Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Ryobi 775r