Ryobi LE720r Manuel d'utilisateur télécharger pdf (Page 7)

OPERATING INSTRUCTIONS

HOLDING THE UNIT WITH EDGER ADD-ON

WARNING:

Always wear eye, hearing, foot

and body protection to reduce the risk of

injury when operating this unit.

Before operating the unit, stand in the operating position

(Figs. 4 & 5). Check for the following:

• The operator is wearing eye protection and proper

clothing.

• The right arm is slightly bent, and the hand is holding

the shaft grip.

• The left arm is straight, and the hand is holding the

handle.

• The unit is at waist level.

• The edger wheel adjusted for proper cut depth and

edger positioned as shown in Figs. 4 or 5.

ADJUSTING EDGER CUTTING DEPTH

1. Loosen the adjustment knob above the wheel

(Fig 6).

2. Slide the wheel to the desired position.

• Raising the wheel increases the cutting depth.

• Lowering the wheel decreases the cutting depth.

3. Tighten the adjustment knob securely.

TIPS FOR BEST EDGING RESULTS

• Keep the cutting attachment perpendicular to the

ground.

• Do not force the edger. Edge the first time at a lesser

depth, then do the area again with a deeper setting.

• Walk the edger at a slow, even pace

• Check the blade condition, as it wears it becomes

smaller, reducing the cutting depth performance.

Replace with a new blade as required.

Fig. 4

Fig. 6

Fig. 5

Raising

Lowering

Depth Adjustment Knob

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Ryobi LE720r Manuel d'utilisateur Page 7