2-Cycle Petrol TrimmerOPERATOR’S MANUALIMPORTANT MANUAL DO NOT THROW AWAYRCT2800AD
10MAINTENANCE SCHEDULEPerform these required maintenance procedures at thefrequency stated in the table. These procedures shouldalso be a part of any
11MAINTENANCE AND REPAIR INSTRUCTIONSFig. 19Fig. 15NOTE: SplitLine™ can only be used with the inner reelwith the slotted holes. Single line can be use
12MAINTENANCE AND REPAIR INSTRUCTIONSAIR FILTER MAINTENANCERemoving the Air Filter/Muffler Cover1.Place the choke lever in Position 2.NOTE: The choke
13SPARK ARRESTOR MAINTENANCE1. Remove air filter/muffler cover. Refer to Removingthe Air Filter/Muffler Cover.2. Locate muffler front and the two (2)
14CLEANINGUse a small brush to clean off the outside of the unit.Do not use strong detergents. Household cleaners thatcontain aromatic oils such as pi
15If further assistance is required, contact your authorized service dealer. CAUSE ACTIONCutting attachment bound with grass Stop the engine and clean
SPECIFICATIONSENGINE*DRIVE SHAFT and CUTTING ATTACHMENT**All specifications are based on the latest product information available at the time of print
2INTRODUCTIONRead the Operator’s Manual(s) and follow all warnings and safety instructions. Failure to do socan result in serious injury to the operat
3READ ALL INSTRUCTIONS BEFORE OPERATING• Read the instructions carefully. Be familiar with thecontrols and proper use of the unit.• Do not operate thi
4SYMBOL MEANING• SAFETY ALERT SYMBOLIndicates danger, warning, orcaution. May be used in conjunctionwith other symbols or pictographs.• WARNING - READ
5RULES FOR SAFE OPERATIONAPPLICATIONSAs a trimmer:• Cutting grass and light weeds• Edging• Decorative trimming around trees, fences, etc.KNOW YOUR UNI
6ASSEMBLY INSTRUCTIONSFig. 2INSTALL THE CUTTING ATTACHMENT SHIELDUse the following instructions if the cutting attachmentshield on your unit is not in
7OIL AND PETROL INFORMATIONNOTE: Dispose of the old petrol/oil mix in accordance toFederal, State and Local regulations.CAUTION: For proper engine ope
8STARTING INSTRUCTIONS1. Mix petrol with oil. Fill petrol tank with petrol/oilmixture. Refer to Oil and Petrol Mixing Instructions.2. Fully press and
9OPERATING INSTRUCTIONSNOTE: Do not rest the Bump Head™ on the groundwhile the unit is running.Some line breakage will occur from:• Entanglement with
Commentaires sur ces manuels