Ryobi RY13010 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel de jardinage Ryobi RY13010. Ryobi RY13010 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
RYOBI ART WORK
Art Part No. : 987000-651 Rev. 02
Where Used : 987000-651
Refer to Drawings for Dimensions.
987000-651
11-19-09 (REV:02)
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
CALL
1-800-860-4050
www.ryobitools.com
Place the engine switch in the ON ( l ) position.
3
Carefully pour fuel into the tank. Avoid spillage. Immediately replace
fuel cap and hand tighten. Wipe up any fuel spillage.
PRIME press the PRIMER BULB 10 times slowly.
SET START lever to " START " position.
Stand beside the trimmer and place your right hand on the
handlebar and your foot on the frame as shown. Using your left hand,
PULL
the starter grip and rope until the engine runs.
1 GALLON
GAS
Move to the rear of the machine and squeeze throttle lever to run.
10x
Set the START lever back to the RUN position.
NOTE: If the engine dies, set the START lever to the RUN position
and pull the starter grip and rope until the engine starts.
START
RUN
6
1
2
4
5
7
8
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole
using the funnel provided.
LUBRICANT
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
1
3
7
6
8
4
2
5
Cold Engine:
Warm Engine:
To Stop:
Move the START lever to the START position and then immediately back to the RUN position.
Pull the starter grip and rope until the engine starts.
NOTE: This will set the carburetor to a fast idle setting for easier starting.
RUN
Place the engine switch in the OFF ( O ) position.
START
Vue de la page 0
1 2

Résumé du contenu

Page 1 - ENGINE STARTING PROCEDURE

RYOBI ART WORKArt Part No. : 987000-651 Rev. 02Where Used : 987000-651 Refer to Drawings for Dimensions.987000-65111-19-09 (REV:02)Material:

Page 2 - 1-800-860-4050

1368425 7BACKPresione lentamente 10 veces la bomba de cebado.La palanca del carburador en la posición " START " ( arranque )Appuyer lentemen

Commentaires sur ces manuels

Pas de commentaire