Ryobi RY13016 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel de jardinage Ryobi RY13016. Ryobi RY13016 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
SET
CHOKE lever to " FULL CHOKE " position.
Do not squeeze throttle trigger.
990000470
6-13-13 (REV:04)
Cold Engine:
To Stop:
DEPRESS the “STOP” switch
to the STOP position.
Carefully pour fuel into the tank. Avoid spillage. Immediately replace
fuel cap and hand tighten. Wipe up any fuel spillage.
PRIME
press the PRIMER BULB 10 times slowly.
1 GALLON
GAS
After 10 seconds,
SET
choke lever to RUN
position and press throttle trigger.
10x
RUN
5
1
2
4
7
LUBRICANT
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.
Later uses: Check engine lubricant level and add lubricant if needed.
For any questions about operating or maintaining your product, call the Ryobi
®
Help Line!
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operators manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operators manual.
CALL
1-800-860-4050
www.ryobitools.com
Warm Engine:
10x
RUN
Press the PRIMER BULB 10 times slowly.
Set choke lever to RUN.
Pull starter grip until the engine runs.
HALF
CHOKE
NOTICE
Do not use E15 or E85 fuel (or fuel
containing greater than 10% ethanol) in
this product. It is a violation of federal
law and will damage the unit and void
your warranty.
5
2
4
6
7
6
7
1
FULL
CHOKE
RUN
HALF
CHOKE
8
3
Press the on/stop switch in the ON ( I ) position.
3
With throttle at idle,
PULL
starter grip
sharply until engine runs. (Max 3 times)
If 60°F or lower, continue to pull starter grip until
engine runs.
If above 60°F, set choke lever to “HALF CHOKE” and
pull starter grip until engine runs.
5
6
8
Vue de la page 0
1 2

Résumé du contenu

Page 1 - ENGINE STARTING PROCEDURE

SET CHOKE lever to " FULL CHOKE " position.Do not squeeze throttle trigger.9900004706-13-13 (REV:04)Cold Engine:To Stop:DEPRESS the “STOP” s

Page 2 - 1-800-860-4050

La palanca del carburador en la posición " FULL CHOKE " ( anegación máxima ). No oprima el gatillo del acelerador.Le levier du volet de dépa

Commentaires sur ces manuels

Pas de commentaire