Ryobi RY64400 Manuel d'utilisateur télécharger pdf

RYOBI ART WORK

Art Part No. : 987000-682 Rev. 03

Where Used : 987000-682

Refer to Drawings for Dimensions.

987000-682

10-15-10 (REV:03)

Material: 60lb. Stock Paper.

Color: Lift-off Bright Pink.

FRONT

To Start:

To Stop:

Carefully pour fuel into the tank. Avoid spillage. Immediately replace

fuel cap and hand tighten. Wipe up any fuel spillage.

Press the PRIMER BULB 10 times slowly or until fuel appears.

Pull starter grip sharply until engine attempts

to run (no more than 4x).

1 GALLON

GAS

10x

Pull starter grip until engine runs (no more than 6x).

NOTE: If engine does not start, return to step 6 and

repeat.

LUBRICANT

ENGINE STARTING PROCEDURE

WARNING: This Engine Starting Procedure is not a substitute for

reading the operator’s manual. To reduce the risk of injury, user must

read and understand operator’s manual before using this product.

Place the STOP SWITCH in the ON position (I).

First time use only: Pour entire contents of engine lubricant bottle into oil fill hole using a funnel.

Later uses: Check engine lubricant level and add lubricant if needed.

For any questions about operating or maintaining your product, call the Ryobi

Help Line!

Your Product has been fully tested prior to shipment to ensure your complete satisfaction.

Troubleshooting tips are also available in your operator’s manual.

Go to www.ryobitools.com and register your new tool on-line.

For additional registration instruction, refer to operator’s manual.

CALL

1-800-860-4050

www.ryobitools.com

Place the STOP SWITCH in the OFF position (O).

Lean the unit back on its wheels so that the

handlebar rests on the ground.

Move to the rear of the machine and

squeeze throttle lever to operate.

5 7

3 12

Set CHOKE lever to " FULL CHOKE".

FULL

CHOKE

Set CHOKE lever to " HALF CHOKE".

HALF

CHOKE

Allow engine to run 10 seconds, set CHOKE lever

to " RUN ".

RUN

6 8

1 2

Résumé du contenu

Page 1 - ENGINE STARTING PROCEDURE

RYOBI ART WORKArt Part No. : 987000-682 Rev. 03Where Used : 987000-682 Refer to Drawings for Dimensions.987000-68210-15-10 (REV:03)Material:

Page 2 - 1-800-860-4050

BACK1 GALLON GAS10x123LUBRICANT RYOBI ART WORKArt Part No. : 987000-682 Rev. 03Where Used : 987000-682 Refer to Drawings for Dimensions.Mate

Plus de documents pour Matériel de jardinage Ryobi RY64400

Voir le document Ryobi RY64400 Manuel d'utilisateur

Ryobi RY64400 Manuel d'utilisateur (52 pages)

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY64400 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel de jardinage Ryobi RY64400. Ryobi RY64400 User Manual Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Matériel de jardinage Ryobi RY64400

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Ryobi RY64400