Ryobi RYI2200H Manuel d'utilisateur télécharger pdf (Page 17)

13 — English

OPERATION

LED DISPLAY

See Figure 2.

Power:

The power indicator will light when the generator is on and

the receptacles are operational.

NOTE: If the generator is overloaded, the power indicator

light will go off.

Overload:

The overload indicator will light if the generator’s wattage/

amperage capacity is exceeded. To reset the generator, re-

move all loads from the generator and press the reset button

(see fig. 1). Add loads back to the generator one at a time

being careful not to exceed the generators wattage rating.

Lubricant:

The oil indicator will light and the engine will automatically

shut off whenever the lubricant level in the engine becomes

low. The engine may not be restarted until sufficient engine

lubricant has been added to the generator.

NOTE: It is normal for the indicator lights to illuminate and/

or blink each time the engine is started. Once the engine

warms up, the lights should default to the pattern above.

CHECKING/ADDING LUBRICANT

See Figure 3.

NOTICE:

Attempting to start the engine before it has been properly

filled with lubricant will result in equipment failure.

Engine lubricant has a major influence on engine perfor-

mance and service life. For general, all-temperature use,

SAE 10W-30 is recommended. Always use a 4-stroke motor

lubricant that meets or exceeds the requirements for API

service classification SJ.

NOTE: Non-detergent or 2-stroke engine lubricants will

damage the engine and should not be used.

 Loosen the screws at the side of the engine cover. Remove

cover and set aside.

 Unscrew the oil cap/dipstick and remove.

 Wipe dipstick clean and re-seat in hole; do not re-thread.

 Remove dipstick again and check lubricant level. Lubricant

level should fall between the minimum and maximum

marks on the dipstick.

 If level is low, add engine lubricant until the fluid level

rises between the minimum and maximum marks on the

dipstick.

 Replace and secure the oil cap/dipstick.

USING FUEL STABILIZER

Fuel gets old, oxidizes, and breaks down over time. Adding

a fuel stabilizer (not included) extends the usable life of fuel

and helps prevent deposits from forming that can clog the

fuel system. Follow fuel stabilizer manufacturer’s directions

for correct ratio of stabilizer to fuel.

Mix fuel stabilizer and gasoline prior to filling the tank

by using a gas can or other approved fuel container and

shaking gently to combine.

NOTE: To control the amount of fuel stabilizer being added

to the engine, always mix fuel stabilizer with gasoline

before fueling the tank rather than adding fuel stabilizer

directly into the generator’s fuel tank.

 Replace and secure the fuel tank cap.

 Start and run the engine for at least 5 minutes to allow

stabilizer to treat the entire fuel system.

OXYGENATED FUELS

NOTICE:

Do not use E15 or E85 fuel (or fuel containing greater

than 10% ethanol) in this product. It is a violation of

federal law and will damage the unit and void your

warranty.

Fuel system damage or performance problems resulting

from the use of an oxygenated fuel containing more than

the percentage of oxygenates stated below are not covered

under warranty.

Ethanol. Gasoline containing up to 10% ethanol by volume

(commonly referred to as E10) is acceptable. E15 and E85

are not.

CHECKING/ADDING FUEL

See Figure 4.

WARNING:

Gasoline and its vapors are highly flammable and ex-

plosive. To prevent serious personal injury and property

damage, handle gasoline with care. Keep away from igni-

tion sources, handle outdoors only, do not smoke while

adding fuel, and wipe up spills immediately.

When adding gas to the generator, make sure the unit is

sitting on a flat, level surface. If the engine is hot, let the

generator cool before adding gas. ALWAYS fill the fuel tank

outdoors with the machine turned off.

 Remove the fuel cap slowly.

 Fill the fuel tank to 1 in. below the top of the fuel neck.

 Replace and secure the fuel cap.

NOTE: Always use unleaded gasoline with a pump octane

rating of 86 or higher. Never use old, stale, or contaminated

gasoline, and do not use an oil/gas mixture. Do not allow dirt

or water into the fuel tank. Do not use E85 fuel.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

Ryobi RYI2200H Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Ryobi RYI2200H