Ryobi BC30 RY30060B Manuel de l'opérateur télécharger pdf (Page 11)

Page 11

ATTACHING THE FRONT HANDLE - CS30

AND SS30

See Figure 4.

1. Remove the front handle, bolt, flat washer, lock washer,

and wing nut from the Owner’s Kit.

2. Install the front handle onto the top side of the drive shaft

housing and move it to a comfortable position.

3. Place the bolt through the front handle

NOTE: The hex bolt head fits inside the hex recess molded

into one side of the handle.

4. Install the flat washer, lock washer, and wing nut.

5. Tighten wing nut securely.

ATTACHING THE “J” BARRIER HANDLE -

BC30

See Figure 5.

A barrier handle must be used for ensuring the best control

and maximizing operator safety when using a brushcutter.

1. Hold the top and bottom clamp snugly in position on the

shaft housing so that handle will be located to the operator's

left.

2. Insert the end of the handle between the clamps.

3. Align the bolt holes and push the long bolt (1/4-20 x 1-1/2 in.)

through the handle side.

4. Place short bolt (1/4-20 x 1 in.) through opposite side of

clamp. Install flat washer, lock washers and hex nuts to

hold the assembly in place.

5. After assembly is complete, adjust the position of the

handle for best balance and comfort.

6. Tighten first the long bolt and then the short bolt.

ASSEMBLY

WING

NUT

FRONT HANDLE

BOLT

Fig. 4

Fig. 5

CLAMP

FLAT WASHER

LOCK WASHER

HEX NUT

STRAP

HANGER

BOLT

1/4-20 x 1 1/2 in.

CLAMP

FRONT

HANDLE

BOLT

1/4-20 x 1 in.

LOCK

WASHER

FLAT WASHER

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi BC30 RY30060B Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi BC30 RY30060B