Ryobi BC30 RY30060B Manuel de l'opérateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Page 12
ATTACHING THE GRASS DEFLECTOR
WARNING:
The line cutting blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact can
result in serious personal injury.
TO ATTACH THE CURVED SHAFT GRASS DEFLECTOR
- CS30
See Figure 6.
1. Press the grass deflector onto the bottom of the curved
shaft as shown.
2. Insert the hex head cap screw through the grass deflector
and the bracket on the curved shaft.
3. Place the flat washer and lock washer on the hex head
cap screw.
4. Place the wing nut on the hex head cap screw and tighten
securely.
TO ATTACH THE STRAIGHT SHAFT GRASS
DEFLECTOR - SS30
See Figure 7.
1. Remove the slotted hex head screw from the grass
deflector.
2. Insert the tab on the mounting bracket in the slot on the
grass deflector.
3. Align the screw hole in the mounting bracket with the
screw hole in the grass deflector.
4. Insert the slotted hex head screw through the mounting
bracket and into the grass deflector.
5. Tighten the screw securely.
ATTACHING THE BRUSHCUTTER GUARD
- BC30
See Figure 8.
The guard is shipped installed on these brushcutter
models. Instructions have been included for reference when
changing from string trimmer operation back to brushcutter
operation.
1. With the string head removed, place the brushcutter guard
on the gear head as shown.
2. Install the three screws from bottom through the guard
and into the gear head.
3. Tighten the screws securely and torque to 40-50 in.lbs.
minimum (finger tight plus 1/4 turn).
ASSEMBLY
GRASS
DEFLECTOR
BRACKET
BOLT
WING NUT
Fig. 6
FLAT
WASHER
LOCK WASHER
Fig. 7
Fig. 8
HEX HEAD
SCREW
STRAIGHT SHAFT
GRASS DEFLECTOR
TAB
SLOT
GEAR HEAD
HEX HEAD
SCREW
BRUSHCUTTER GUARD
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Commentaires sur ces manuels

Pas de commentaire