Ryobi BC30 RY30060B Manuel de l'opérateur Page 25

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 24
Page 25
WARRANTY
RYOBI TECHNOLOGIES INC. LIMITED WARRANTY FEDERAL AND CALIFORNIA EMISSION
CONTROL SYSTEMS NONROAD AND SMALL OFF-ROAD ENGINES
The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Ryobi Technologies Inc. are pleased
to explain the Emission Control System Warranty on your nonroad or small off-road engine. In California, new small off-road engines
must be designed, built and equipped to meet the state's stringent anti-smog standards. In other states, new 2000 and later model year
nonroad engines must be designed, built and equipped, at the time of sale, to meet the U.S. EPA regulations for small nonroad engines.
The nonroad engine must be free from defects in materials and workmanship which cause it to fail to conform with U.S. EPA standards
for the first two years of engine use from the date of sale to the ultimate purchaser. Ryobi Technologies Inc. must warrant the emission
control system on your nonroad or small off-road engine for the period of time listed above provided there has been no abuse, neglect, or
improper maintenance of your nonroad or small off-road engine.
Your emission control system may include parts such as the carburetor or fuel injection system, the ignition system, the catalytic con-
verter. Also included may be hoses, belts, and connectors and other emission related assemblies.
Where a warrantable condition exists, Ryobi Technologies Inc. will repair your nonroad or small off-road engine at no cost to you, includ-
ing diagnosis (if the diagnostic work is performed at an authorized dealer), parts, and labor.
MANUFACTURER'S WARRANTY COVERAGE:
The 1995 and later small off road engines are warranted for two years in California. In other states, 1997 and later model year nonroad
engines are also warranted for two years. If any emission-related part on your engine is defective, the part will be repaired or replaced by
Ryobi Technologies Inc. free of charge.
OWNER'S WARRANTY RESPONSIBILITIES
(a) As the nonroad or small off-road engine owner, you are responsible for the performance of required maintenance listed in your
owner's manual. Ryobi Technologies Inc. recommends that you retain all receipts covering maintenance on your nonroad or small
off-road engine, but Ryobi Technologies Inc., cannot deny warranty solely for the lack of receipts or for your failure to ensure the per-
formance of all scheduled maintenance. Any replacement part or service that is equivalent in performance and durability may be used
in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of the engine manufacturer.
(b) As the nonroad or small off-road engine owner, you should be aware, however, that Ryobi Technologies Inc., may deny you warranty
coverage if your nonroad or small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved
modifications.
(c) You are responsible for presenting your nonroad or small off-road engine to a Ryobi Technologies Inc., service dealer as soon as a
problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.
If you have any questions regarding your warranty rights and responsibilities, you should contact a Ryobi Technologies Inc., Customer
Representative at 1-800-860-4050.
COVERAGE:
Ryobi Technologies Inc. warrants to the ultimate purchaser and each subsequent purchaser that your nonroad or small off-road engine
will be designed, built and equipped, at the time of sale, to meet all applicable regulations. Ryobi Technologies Inc. also warrants to the
initial purchaser and each subsequent purchaser that your nonroad or small off-road engine is free from defects in materials and work-
manship which cause the engine to fail to conform with applicable regulations for a period of two years. The 1995 and later small off
road engines are warranted for two years in California. In all other states for 1997 and later model years, EPA requires manufacturers to
warrant non-road engines for two years. These warranty periods will begin on the date the nonroad or small off-road engine is purchased
by the initial purchaser. If any emission-related part on your engine is defective, the part will be replaced by Ryobi Technologies Inc. at no
cost to the owner.
Ryobi Technologies Inc. shall remedy warranty defects at any authorized Ryobi Technologies Inc. engine dealer or warranty station.
Any authorized work done at an authorized dealer or warranty station shall be free of charge to the owner if such work determines that
a warranted part is defective. Any manufacturer-approved or equivalent replacement part may be used for any warranty maintenance
or repairs on emission-related parts, and must be provided free of charge to the owner if the part is still under warranty. Ryobi Tech-
nologies Inc. is liable for damages to other engine components caused by the failure of a warranted part still under warranty.
The California Air Resources Board's Emission Warranty Parts List specifically defines the emission-related warranted parts. (EPA's
regulations do not include a parts list, but EPA considers emission-related warranted parts to include all the parts listed below.)
These warranted parts are: Carburetor, Spark Plug, Ignition, Air Filter and Fuel Filter.
MAINTENANCE REQUIREMENTS
The owner is responsible for the performance of the required maintenance as defined by Ryobi Technologies Inc. in the operator's
manual.
LIMITATIONS
The Emission Control Systems Warranty shall not cover any of the following:
(a) repair of replacement required because of misuse or neglect, lack of required maintenance, repairs improperly performed or replace-
ments not conforming to Ryobi Technologies Inc. specifications that adversely affect performance and/or durability, and alterations
or modifications not recommended or approved in writing by Ryobi Technologies Inc., and
(b) replacement of parts and other services and adjustments necessary for required maintenance at and after the first scheduled re-
placement point.
THE FOLLOWING CARB STATEMENT ONLY APPLIES TO MODEL NUMBERS REQUIRED TO
MEET (CARB) REQUIREMENTS.
Vue de la page 24
1 2 ... 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire