Ryobi EJ101 Manuel de l'opérateur télécharger pdf (Page 6)

Page 6

■ DRUGS, ALCOHOL, MEDICATION. Do not oper-

ate tool while under the influence of drugs, alcohol,

or any medication.

■ WHEN SERVICING USE ONLY IDENTICAL

RYOBI REPLACEMENT PARTS.

■ WARNING: TO AVOID POSSIBLE SERIOUS IN-

JURY, KEEP HANDS AND FINGERS FROM BE-

TWEEN THE MOTOR HOUSING AND SAW

BLADE CLAMP.

■ SAVE THESE INSTRUCTIONS. Refer to them

frequently and use them to instruct others who may

use this tool. If you loan someone this tool, loan

them these instructions also.

SAVE THESE INSTRUCTIONS

RULES FOR SAFE OPERATION

BEFORE OPERATING

• Read the instructions carefully. Be familiar with the controls

and proper use of the unit.

• Do not operate this unit when tired, ill, or under the

influence of alcohol, drugs, or medication.

• Children and teens under the age of 15 must not use the

unit, except for teens guided by an adult.

• Inspect the unit before use. Replace damaged parts.

Check for fuel leaks. Make sure all fasteners are in place

and secure. Replace blades that are cracked, chipped, or

damaged in any way. Make sure blades are properly

installed and securely fastened. Make sure the shoe is

secured properly and positioned as recommended. Failure

to so can result in personal injury to the operator and

bystanders, as well as damage to the unit.

• Be aware of the risk of injury to the head, hands and feet.

• Clear the work area before each use. Remove all objects

such as nails or wire which can contact the blade. Clear

the area of children, bystanders, and pets. At a minimum,

keep all children, bystanders, and pets outside a 50 feet

(15.2 m) radius; there still may be a risk to bystanders

from thrown objects. Bystanders should be encouraged

to wear eye protection. If you are approached, stop the

engine immediately.

• Squeeze the throttle control and check that it returns

automatically to the idle position. Make all adjustments or

repairs before using unit.

SAFETY WARNINGS FOR GASOLINE ENGINES

• WARNING: Gasoline is highly flammable, and its vapors

can explode if ignited. Take the following precautions:

• Store fuel only in containers specifically designed and

approved for the storage of such materials.

• Always stop the engine and allow it to cool before filling

the fuel tank. Never remove the cap of the fuel tank, or add

fuel, when the engine is hot. Never operate the unit

without the fuel cap securely in place. Loosen the fuel

tank cap slowly to relieve any pressure in the tank.

• Mix and add fuel in a clean, well-ventilated area outdoors

where there are no sparks or flames. Slowly remove the

fuel cap only after stopping engine. Do not smoke while

fueling or mixing fuel. Wipe up any spilled fuel from the

unit immediately.

• Avoid creating a source of ignition for spilled fuel. Do not

start the engine until fuel vapors dissipate.

• Move the unit at least 50 feet (15.2 m) from the fueling

source and site before starting the engine. Do not smoke,

keep sparks and open flames from the area while adding

fuel or operating the unit.

WHILE OPERATING

• Never start or run the unit inside a closed room or building.

Breathing exhaust fumes can kill. Operate this unit only in

a well ventilated area outdoors.

•Wear safety glasses or goggles that are marked as

meeting ANSI Z87.1-1989 standards, and ear/hearing

protection when operating this unit. Wear a face or dust

mask if the operation is dusty.

•Do not wear loose clothing, jewelry, sandals or go barefoot.

Secure hair above shoulder level.

• This unit has a clutch. The blade remains stationary when

the engine is idling. If it does not, have the unit adjusted

by an authorized service technician.

• Be sure the blade is not in contact with anything before

starting the unit.

• Use the unit only in daylight or good artificial light.

• Avoid accidental starting. Be in the starting position

whenever pulling the starter rope. The operator and unit

must be in a stable position while starting. See Starting/

Stopping Instructions.

• Use the right tool. Only use this tool for the purpose

intended.

• Do not overreach. Always keep proper footing and balance.

• Always hold the unit with both hands when operating.

• Keep hands, face, and feet at a distance from all moving

parts. Do not touch the blade when it is rotating.

• Do not touch the engine or muffler. These parts get

extremely hot from operation. When turned off they

remain hot for a short time.

• Do not operate the engine faster than the speed needed

for the cut being made. Do not run the engine at high

speed when not cutting.

• If you strike a foreign object, stop the engine immediately

and check for damage. Do not operate before repairing

damage. Do not operate the unit with loose or damaged

parts.

• Stop and switch the engine to off for maintenance, repair,

or for changing blades.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi EJ101 Manuel de l'opérateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi EJ101