Ryobi RY70105A Manuel de l'opérateur télécharger pdf (Page 15)

WARNING

Never start or run the engine inside a closed or

poorly ventilated area; breathing exhaust fumes

can kill.

TO START A COLD ENGINE:

1 Lay trimmer on a flat, bare surface.

2 Push primer bulb 8 to 10 times.

NOTE: Do not squeeze the throttle trigger before engine

starts. Squeezing the throttle trigger at this time will prevent

the unit from starting.

3 Move the lever to the “COLD START” position.

See

Figure 17.

4 Pull the starter rope until engine runs.

5 Allow the engine to warm up for 4-10 seconds.

6 Depress the throttle interlock, then squeeze and release

the throttle trigger. This allows the choke to automati-

cally set to the “WARM START” position. Your unit is

now ready for use.

NOTE: The lever will automatically set to the “WARM

START” position after the throttle trigger is squeezed for

the first time.

TO START A WARM ENGINE:

1. Lay trimmer on a flat, bare surface.

2. Choke lever should already be in the “WARM

START” position. If not, squeeze and release throttle

trigger. Pull the starter rope until unit runs.

TO STOP THE ENGINE:

To stop the engine, depress the switch to the “O” position.

STARTING AND STOPPING

See Figures 16 and 17.

NOTE: The unit is equipped with an automatic choke feature.

The starting instructions for this feature are different from units

with a manual choke. Be sure to read and follow the starting

instructions below.

OPERATION

PRIMER BULB

LEVER

Fig. 17

WARM START

POSITION

COLD START

POSITION

IGNITION SWITCH

I = ON TO RUN

O = OFF TO STOP

Fig. 16

THROTTLE

TRIGGER

THROTTLE

INTERLOCK

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY70105A Manuel de l'opérateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi RY70105A