Ryobi RY70105A Manuel de l'opérateur télécharger pdf (Page 7)

ATTACHING THE POWER HEAD TO THE

TRIMMER ATTACHMENT

See Figure 2.

ASSEMBLY

REMOVING THE ATTACHMENT FROM THE

POWER HEAD

For removing or changing the attachment:

1. Loosen the knob.

2. Push in the button and twist the shafts to remove and

separate ends.

ATTACHING THE STORAGE HANGER

See Figure 3.

There are two ways to hang your attachment for storage.

■■

■ To use the hanger cap, push in the button and place the

hanger cap over end of the lower end attachment shaft.

Slightly rotate the cap from side to side until the button

locks into place.

■■

■ The secondary hole in the attachment shaft can also be

used for hanging.

WARNING:

Be certain the knob is fully tightened before operating

equipment; check it periodically for tightness during use

to avoid serious injury.

The trimmer attachment connects to the power head by

means of a coupler device.

1. Loosen the knob on the coupler of the power head shaft

and remove the end cap from the attachment.

2. Push in the button located on the trimmer attachment

shaft. Align the button with the guide recess on the

power head coupler and slide the two shafts together.

Rotate the trimmer attachment shaft until the button

locks into the positioning hole.

NOTE: If the button does not release completely in the

positioning hole, the shafts are not locked into place.

Slightly rotate from side to side until the button is locked

into place.

3. Tighten the knob securely.

WARNING:

Never attach or adjust any attachment while power head

is running. Failure to stop the engine can cause serious

personal injury.

Fig. 2

COUPLER

KNOB

TRIMMER ATTACHMENT

TRIMMER SHAFT

POSITIONING

HOLE

GUIDE

RECESS

Fig. 3

BUTTON

HOLE

HANGER CAP

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY70105A Manuel de l'opérateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi RY70105A