Ryobi CFS1500 Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
Page 7
WARNING:
The double insulated system is intended to protect the
user from shock resulting from a break in the tool's
internal wiring. Observe all normal safety precautions
related to avoiding electrical shock.
WARNING:
To prevent accidental starting or electrical shock that
could cause possible serious personal injury, assemble
all parts to your sander before connecting it to power
supply. Sander should never be connected to power
supply when you are assembling parts, making
adjustments, installing or removing sanding sheets,
cleaning, or when not in use.
PACKING LIST:
1. Sander
2. Light Scrubbing pad (White) (1)
3. Heavy Duty Scrubbing pad (Red) (1)
4. Polishing pad (Gray) (1)
5. 60-grit sanding sheets (2)
6. 120-grit sanding sheets (3)
7. 240-grit sanding sheets (2)
8. Operators Manual (1)
(Not shown)
9. Warranty and Registration Card (1)
(Not shown)
Fig. 2
1
2
3
4
5
6
7
Your sander has been shipped completely assembled and
ready for use.
See Figure 2.
Inspect it carefully to make
sure no breakage or damage has occurred during shipping.
If any parts are damaged or missing, contact your nearest
authorized service center to obtain replacement parts before
attempting to operate sander.
Carefully lift sander from the carton and place it on a level
work surface.
Do not discard the packing materials until you have
carefully inspected the sander, identified all parts, and
satisfactorily operated your new sander.
WARNING:
If any parts are damaged or missing, do not operate your
sander until the parts are replaced. Failure to do so could
result in possible serious personal injury.
UNPACKING
FEATURES
DOUBLE INSULATION
Your Ryobi power tool is double insulated. This means you
are separated from the tool’s electrical system by two
complete sets of electrical insulation. This extra layer of
insulation is intended to protect the user from electrical shock
due to a break in the wiring insulation. All exposed metal
parts are isolated from the internal metal motor components
with protecting insulation. Double insulated tools do not need
to be grounded.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire