Ryobi P3320 Manuel d'utilisateur télécharger pdf (Page 5)

5 – English

ELECTRICAL

the minimum wire size required in an extension cord. Only

round jacketed cords listed by Underwriter’s Laboratories

(UL) should be used.

When using this product outdoors, use an extension cord that

is designed for outside use. This type of cord is designated

with “WA” or “W” on the cord’s jacket.

Before using any extension cord, inspect it for loose or

exposed wires and cut or worn insulation.

**Ampere rating (on product data plate)

0-2.0 2.1-3.4 3.5-5.0 5.1-7.0 7.1-12.0 12.1-16.0

Cord Length Wire Size (A.W.G.)

25´ 16 16 16 16 14 14

50´ 16 16 16 14 14 12

100´ 16 16 14 12 10 —

**Used on 12 gauge - 20 amp circuit

NOTE: AWG = American Wire Gauge

WARNING:

Keep the extension cord clear of the working area.

Position the cord so that it will not get caught on lumber,

tools, or other obstructions while you are working with

this product. Failure to do so can result in serious

personal injury.

WARNING:

Check extension cords before each use. If damaged

replace immediately. Never use a product with a damaged

cord since touching the damaged area could cause

electrical shock resulting in serious injury.

DOUBLE INSULATION

Double insulation is a concept in safety in electric products,

which eliminates the need for the usual three-wire grounded

power cord. All exposed metal parts are isolated from the

internal metal motor components with protecting insulation.

Double insulated products do not need to be grounded.

WARNING:

The double insulated system is intended to protect the

user from shock resulting from a break in the product’s

internal wiring. Observe all normal safety precautions to

avoid electrical shock.

NOTE: Servicing of a product with double insulation requires

extreme care and knowledge of the system and should

be performed only by a qualified service technician. For

service, we suggest you return the product to your nearest

authorized service center for repair. Always use original

factory replacement parts when servicing.

ELECTRICAL CONNECTION

This product should be connected to a power supply that

is 120 volts, AC only (normal household current), 60 Hz.

Do not operate this product on direct current (DC) through

the power cord. A substantial voltage drop will cause a loss

of power and the motor will overheat. If the product does

not operate when plugged into an outlet, double-check the

power supply.

EXTENSION CORDS

When using a product at a considerable distance from a

power source, be sure to use an extension cord that has

the capacity to handle the current the product will draw. An

undersized cord will cause a drop in line voltage, resulting in

overheating and loss of power. Use the chart to determine

1 2 3 4 5 6 7 8 9 10 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi P3320 Manuel d'utilisateur Page 5

Commentaires sur ces manuels