Ryobi R10632 Manuel de l'opérateur télécharger pdf (Page 16)

Page 16

454

505

3030

2222

POSITIVE 0° BEVEL STOP

See Figure 21.

Your saw has a positive 0° bevel stop, that has been factory

adjusted to assure 0° angle of your saw blade when making

90° cuts. However, misalignment can occur during shipping.

TO CHECK

■ Remove battery pack from saw.

WARNING:

Failure to remove battery pack from saw could result in

accidental starting causing possible serious personal

injury.

■ Place your saw in an upside down position on workbench.

See Figure 21.

■ Using a carpenter's square, check squareness of saw

blade to the base of your saw.

TO ADJUST

■ Remove battery pack from saw.

WARNING:

Failure to remove battery pack from saw could result in

accidental starting causing possible serious personal

injury.

■ Loosen bevel adjustment knob.

■ Loosen hex nut securing adjustment screw.

■ Turn screw and adjust base until square with saw blade.

■ Tighten hex nut and bevel adjustment knob securely.

WARNING:

Attempting to make cuts without bevel adjustment knob

securely tightened can result in serious injury.

TO POCKET CUT

See Figure 22.

WARNING:

Always adjust bevel setting to zero before making a pocket

cut. Attempting a pocket cut at any other setting can result

in loss of control of your saw possibly causing serious injury.

Adjust the bevel setting to zero, set blade to correct blade

depth setting, and swing the lower blade guard up using the

lower blade guard handle.

Always raise the lower blade guard with the handle to

avoid serious injury.

While holding lower blade guard by the handle, firmly rest the

front of the base flat against the workpiece with the rear of the

Fig. 21

POCKET CUT

Fig. 22

LOWER BLADE

GUARD HANDLE

LOWER

BLADE GUARD

handle raised so the blade does not touch the workpiece.

See Figure 22.

Depress the lock-off button and squeeze the switch trigger to

start your saw. Always let the blade reach full speed then

slowly lower blade into the workpiece until base is flat

against workpiece.

After you complete your cut release the trigger and allow the

blade to come to a complete stop. After the blade has stopped,

remove it from the workpiece. Corners may then be cleared out

with a hand saw or sabre saw.

WARNING:

Never tie the lower blade guard in a raised position.

Leaving the blade exposed could lead to serious injury.

ADJUSTMENT

SCREW

HEX NUT

POSITIVE 0

BEVEL STOP

BEVEL

ADJUSTMENT

KNOB

BLADE

CARPENTER'S

SQUARE

OPERATION

1 2 ... 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi R10632 Manuel de l'opérateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Fournitures d'outils à main Ryobi R10632