Ryobi RY6201 Manuel de l'opérateur télécharger pdf (Page 17)

Page 17

4545

5050

3030

2222

TO RIP CUT

OPTIONAL RIP GUIDE (EDGE GUIDE)

See Figure 23.

Use a guide when making long or wide rip cuts with your saw.

An optional rip guide with a five inch scale is available or you

can make an efficient rip guide by clamping a straight edge

to your workpiece. Secure the workpiece. Using C-clamps,

firmly clamp a straight edge to the workpiece and guide the

saw along the straight edge to achieve a straight rip cut. Do

not bind the blade in the cut. If using the optional rip guide,

see the following instructions and figure 24.

TO ASSEMBLE OPTIONAL RIP GUIDE

See Figure 24.

■ Remove battery pack from saw.

WARNING:

Failure to remove battery pack from saw could result in

accidental starting causing possible serious personal

injury.

■ Place rip guide through holes in saw base as shown in

figure 24.

■ Adjust rip guide to the width needed.

■ Tighten rip guide screw (wing screw) securely.

When using a rip guide, position the face of the rip guide

firmly against the edge of workpiece. This makes for a true

cut without pinching the blade. The guiding edge of workpiece

must be straight for your cut to be straight. Use caution to

prevent the blade from binding in the cut.

Fig. 23

4545

5050

3030

2222

Fig. 24

PLACE RIP

GUIDE THRU HOLES

RIP GUIDE

(EDGE GUIDE)

RIP

GUIDE SCREW

(WING SCREW)

STRAIGHT

EDGE

ALTERNATE METHOD

FOR RIP CUTTING

C-CLAMPS

WORKPIECE

OPERATION

1 2 ... 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY6201 Manuel de l'opérateur Page 17

Commentaires sur ces manuels