Ryobi P731 Manuel d'utilisateur télécharger pdf (Page 10)

10 — English

OPERATION

ACCESSORIES

See Figures 11 - 13, page 14.

The supplied accessories perform a variety of functions.

The tapered adaptor can be used on smaller pinch valves

to inflate items like floats and children’s toys, which usually

require the user to inflate them by blowing air into them. The

sport ball needle can be used to inflate any type of sports ball

or any other item that requires an inflation sport ball needle.

NOTE: When inflating items of 10 PSI, .69 BAR, 69 kPa or

less, inflate in short bursts and check after each burst by

feel or with a calibrated measuring device to determine ac-

curate pressure.

To use the sport ball needle:

 Insert sport ball needle into sports ball valve and inflate.

 Remove sport ball needle after inflation.

NOTE: Pressure required for most sports balls is too low for

accurate reading on gauge.

The Presta valve adaptor can be used for Presta valve stems

as described below. (See Figure 11). Before inflating a tire

with a Presta valve, loosen the locking nut on the valve stem

to inflate. Once inflation is complete, tighten the locking nut

to seal the tire valve.

To use the Presta valve adaptor:

Loosen Presta valve locking nut.

Thread Presta valve adaptor onto valve stem with larger

open end toward wheel.

Position the air chuck clamp in the unlock position.

Clamp the end of the air chuck down onto the Presta

valve adaptor by pressing air chuck clamp down until it

locks into place.

After inflation, remove air chuck and tighten locking nut.

ACCESSORIES STORAGE

See Figure 14, page 14.

When not in use, adaptors and needles provided with the

inflator can be placed in the storage area located on the

right side of the tool.

HOSE STORAGE

See Figures 14 - 15, page 14.

When not in use, the hoses provided with the inflator can

be placed in the storage areas located on both sides of the

inflator.

DEFLATING WITH THE LOW PRESSURE HOSE

See Figure 8, page 13.

The low pressure hose, when placed in the deflator, can be

used to remove air from inflated items.

Place the hose inside the deflator.

 Press the low pressure (I) switch to start deflating.

 When the item has been deflated, turn the switch off.

Remove the hose by pulling if from the deflator.

Store the hose in hose wrap on the left side of the product.

INFLATING WITH THE HIGH PRESSURE

HOSE

See Figure 9, page 13.

The air chuck on the high pressure hose can be used without

adaptors to inflate tires or with any application that has a

valve stem that fits the air chuck opening.

NOTE: When inflating items of 10 PSI, .69 BAR, 69 kPa or

less, inflate in short bursts and check after each burst by

feel or with a calibrated measuring device to determine ac-

curate pressure.

Press mode button to activate.

Set desired pressure.

Place air chuck on valve stem and lock in place.

 Press the high pressure (II) switch to start inflating.

 When the desired pressure is reached, turn the switch

off.

Remove the hose and store in hose wrap on the right side

of the product.

Press and hold the mode button to deactivate the display.

NOTE: Stand 10 feet away from item being inflated.

INFLATING WITH THE HIGH PRESSURE AIR

HOSE AND ACCESSORIES

See Figure 10 - 13, pages 13 - 14.

The high pressure air hose can be used with the provided

adaptors to inflate a variety of items.

To install accessory: insert adaptor (or needle) into air

chuck and push air chuck clamp down until it locks into

place. Inflate to desired pressure.

Remove accessory by lifting air chuck clamp up and

pulling the adaptor (or needle) from air chuck.

INFLATING MANUALLY FOR HIGH AND LOW

PRESSURE APPLICATIONS

 Connect either high or low pressure hose to item to be

inflated.

 Depress power switch to proper switch (low or high pres-

sure) until desired pressure is reached.

NOTE: Stand 10 feet away from item being inflated.

 Turn off power switch.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi P731 Manuel d'utilisateur Page 10

Commentaires sur ces manuels