Ryobi 247.370380 Manuel de l'opérateur télécharger pdf (Page 11)

SECTION5: OPERATINGYOURLAWNMOWER

CordConnection

ExtensionCordSelection

Listed below are the lengths of extension cord and

corresponding acceptable cord ratings.

50' Cord -- use 16AWG

100' Cord -- use 14 AWG

150' Cord --use 12AWG

In all cases, the extension cord should be a UL listed

cord set suitable for outdoor use.

IMPORTANT: Using any other length or rating of cord

will diminish the performance and possibly the life of the

electric motor, and may also cause breakers to trip or

fuses to blow in your home's fusebox.

CordRestraint

Attach the extension cord (not provided with unit) to

the cord restraint as follows.

Form a small loop in the extension cord. Allow

enough excess cord to make the connection to the

motor!blade control (approximately 7 inches).

Slip the loop through the slot on the bottom of the

cord restraint, and up over the tab, to prevent

disconnection from the motor/blade control during

operation.

Keep the cord restraint as close to the motor/blade

control as possible. See Figure 7.

Cord Restraint

Extension Cord

Figure 8

ConnectingtotheM0t0r/BladeControlAssembly

Connect the plug on the extension cord fully onto the

plug on the motor / blade control. The mower is

equipped with a polarized AC power plug (one blade of

the plug is wider than the other), which willfit into the

plug on the extension cord only one way. If unable to

make a full connection, try reversing the plug on the

extension cord. Should the plugs stillfail to fit, contact

your service dealer for assistance. Do not defeat the

safety purpose of the polarized plug.

Connectingto the ElectricPowerSource

WARNING: This mower should be operated

on a 15 AMP circuit. If you experience difficulty in

starting with a standard 15 AMP fuse or circuit

breaker, contact your nearest authorized service

facility. Do not use a higher rated fuse or breaker

without consulting your power company.

Plug the extension cord into any convenient 110-120

volt 60 cycle A.C. outlet or receptacle for your source of

power. This outlet may be located either out-of-doors or

indoors. To avoid blowing fuses, pick an outlet that is

not overloaded. Your mower will operate satisfactorily

on a circuit that is fused for 15 amperes. Do not use

oversize fuses without consulting an electrician. If an

inside receptacle is used, the extension cord can be

taken out either through the doorway or a window.

Startingthe MotorandBlade

NOTE: For best results, raise the wheels to the highest

cutting position until it is determined which height is

best for your lawn. See Cutting Height Adjustment in

the Making Adjustments section.

Motor/Blade Control Lever

Engaged Position

Blade Turning)

Position

Blade Stopped)

Reset Button

P,og

Upper Handle

Figure 9

To engage the motor and blade, first be certain to follow

the previous steps for connecting a suitable extension

cord, then referring to Figure 9:

Stand behind the unit and depress the locking

button.

While holding the locking button down, pullthe

motor / blade control lever and hold itagainst the

upper handle.

Release the locking button.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi 247.370380 Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi 247.370380