Ryobi 247.370380 Manuel de l'opérateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
SECTION9: TROUBLESHOOTINGGUIDE
Trouble Possible Cause(s)
Mower not starting. Cord disconnected from the motor/
blade control.
Motor/blade control switch defective.
Extension cord not connected to a
source of power.
Circuit breaker on the mower or in the
house receptacle tripped.
Too much workload on the mower.Circuit breaker on the mower
tripping.
Mower cutting grass
unevenly.
Hard to push.
Mower vibrating at higher
speed.
Fuse blown; outlet overloaded.
Lawn rough or uneven.
Cutting height not set properly.
High grass or cutting height too low.
Rear of mower housing and blade
dragging in heavy grass.
Bent motor shaft.
Blade is unbalanced.
Cord disconnects frequently. Extension cord is not properly attached
to the cord restraint.
Old, worn, or loose extension cord.
Corrective Action
Reconnect the cord keeping the cord restraint close
to the motor/blade control.
Replace motor/blade control switch.
Connect the extension cord to a 110-120 volt 60
cycle A.C. receptacle.
Reset the circuit breaker following instructions in
the Maintenance section of this manual.
Raise the cutting height, reset the circuit breaker on
the mower, take a smaller width of cut, and walk
slowly.
Connect to an outlet that is fused for 15 amperes.
Reset the circuit breaker and start the mower again.
Move the wheels to a higher cutting height position.
All wheels must be placed in the same cutting
height for the mower to cut evenly.
Raise cutting height.
Raise cutting height.
Stop the motor, disconnect the power source and
inspect for damage. Repair before restarting. If
vibration persists, take it to a service dealer.
Balance the blade by grinding each cutting edge
equally.
Reconnect the extension cord to the cord restraint
on the guide rod.
Replace extension cord.
15
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire