Ryobi 247.370380 Manuel de l'opérateur télécharger pdf (Page 8)

Align the holes in the lower handle with those of the

upper handle and insert the hex bolts through both

holes.

On the left side, install the lock washer and hex nut

and tighten finger tight.

On the right side, insert the hex nut into the hex

hole in the cord insulator and thread onto the hex

bolt on the dght side. Make certain that the curved

portion of the cord insulator is resting flush against

the upper handle.

Tighten the hardware firmly using an adjustable

wrench or suitable tightening tool.

Refer to Figure 2 for proper alignment of hardware

and handles.

Attachingthe Blade/ MotorControlto the Upper

Handle

Holding the blade / motor control, which is attached

to the mower, route the power cord as it is shown in

Figure 2 along the right side of the handle.

Mount the blade / motor control to the upper handle

by inserting its two pedestals into the two holes in

the upper handle. Refer to Figure 2 for correct

positioning on the upper handle.

Close the rear cover on the blade / motor control

and using the small washer head screws included

in the hardware kit, screw them into the holes in the

rear cover with a phillips screwdriver, thus securing

the blade / motor control to the upper handle.

Route the power cord through the cord insulator on

the right handle as shown in Figure 3.

Upper Handle

Hex Nut

Lower Handle

Power Cord

Figure 3

InstallingGuideRodandCordRestraint

The guide rod and cord restraint need to be installed on

the upper handle of the lawn mower. To install, see

Figure 4 and continue:

Upper Handle

Cord Restraint

Guide Rod

Figure 4

Slide the cord restraint onto the guide rod as shown

in Figure 4.

Standing behind the unit, working on the left portion

of the upper handle, insert the Z-end of the guide

rod into the hole on the outer part of the upper

handle.

With the left part of the guide rod inserted in the

upper handle, bring the other end of the guide rod

around the outside of the upper handle on the right

side, and insert the end into the hole on the inner

portion of the upper handle. Refer to Figure 4 for

proper mounting position.

AssemblingGrassCatcher

WARNING: Never operate the mower without

the proper trail shield, discharge cover, grass

catcher, blade/motor control or other safety

protective devices in place and working, Never

operate the mower with damaged safety devices,

Failure to do so can result in personal injury,

Bagger Cover

Attaching Slots_

Grass Bag

Figure 5

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi 247.370380 Manuel de l'opérateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi 247.370380