7
ASSEMBLY
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Using the unit
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create ac-
cessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible seri-
ous personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
Align raised tabs on blower housing outlet to the slots
on upper tube; slide together and tighten securely by
twisting. Check tightness after initial use and retighten
if needed.
Attach desired nozzle (high velocity nozzle or sweeper
nozzle) to upper blower tube by aligning raised tabs on
upper blower tube; slide together and tighten securely by
twisting. Check tightness after initial use and retighten
if needed.
To remove the tubes, rotate the tubes to unlock them
and remove from the blower housing outlet.
INSTALLING THE VACUUM BAG
See Figures 3 - 4.
Remove the nozzle and upper blower tube from the
blower by twisting and removing from blower housing
outlet.
Unzip the vacuum bag and place the adaptor inside
as shown. Push the vacuum bag adaptor through the
opening opposite the zipper. The wider end of the adap-
tor will remain on the inside of the vacuum bag when
installed properly.
Align the raised slots on the vacuum bag adaptor with
the raised locking tabs on the blower housing outlet;
push the bag adaptor onto the housing. Twist to lock
into place.
Rotate the vacuum bag until the shoulder strap is up-
right.
Make sure the vacuum bag is zipped and closed before
starting the unit.
INSTALLING THE VACUUM TUBES
See Figures 5 - 6.
WARNING:
Rotating impeller blades can cause severe injury.
Always stop the engine and ensure impeller blades
have stopped rotating before opening the vacuum
door or installing/changing tubes. Do not put hands or
any other object into the vacuum tubes while they are
installed on the unit.
To install the vacuum tubes:
Secure the upper and lower vacuum tubes together by
aligning the raised locking tabs with the raised slots.
Tap tube assembly on ground until the screw holes
in lower tube are in the raised slot of the upper tube.
Secure with supplied screws.
Depress door tab using a flathead screwdriver and open
vacuum inlet door.
Align tabs on housing with tube assembly.
Tighten screws on upper vacuum tube to secure to
blower housing.
To remove the vacuum tubes:
Loosen screws of the upper vacuum tube by turning
counterclockwise.
Remove the vacuum tube assembly from the blower
housing.
Close the vacuum inlet cover door securely.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels