Ryobi ELS-52 Manuel d'utilisateur télécharger pdf (Page 23)

OPERATION

■ Using the right hand, push down and hold the on/off

switch.

■ Push down and hold the hydraulic control lever with

the left hand. With both the lever and the on/off switch

activated, the ram will push the log into the wedge

and split the wood.

■ Once the log is split, release both controls to return

the ram to the starting position.

FREEING A JAMMED LOG (Fig. 9 - 10)

■ Release both controls.

■ After the ram is back at the starting position, insert a

wood wedge under the jammed log.

■ Start the log splitter to push the wood wedge (14)

completely under the jammed log.

■ If the log is still jammed, repeat the above steps as

needed using a thicker angled wood wedge until the

log is completely freed.

Note: Never try to knock the jammed log off the

splitter. Doing so may damage the tool or may cause

the log to fly up and hit someone causing injury.

MAINTENANCE

WARNING

When servicing, use only identical Ryobi

replacement parts. Use of any other parts may

create a hazard or cause product damage.

WARNING

Always wear safety goggles or safety glasses

with side shields during power tool operation or

when blowing dust. If operation is dusty, also

wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING

Do not at any time let brake fluids, gasoline,

petroleumbased products, penetrating oils, etc.,

come in contact with plastic parts. Chemicals can

damage, weaken or destroy plastic which may

result in serious personal injury.

LUBRICATION

All of the bearings in this tool are lubricated with a

sufficient amount of high grade lubricant for the life of the

unit under normal operating conditions. Therefore, no

further lubrication is required.

REPLACING HYDRAULIC OIL (Fig. 11-12)

The hydraulic oil in the log splitter needs to be changed

every 150 hours of use.

■ Unplug the log splitter.

■ Position the log splitter so that the motor end is

slightly higher than the oil drain plug (Fig. 12).

■ Using an 8 mm hex key, remove the oil drain bolt.

■ Drain the hydraulic oil from the oil tank into a four liter

capacity container.

■ Once the oil has drained from the oil tank, turn the log

splitter on the end with the wheels (Fig. 11).

■ Refill the oil tank with fresh hydraulic oil (3.5L –

viscosity index 22).

■ Place the cleaned dipstick into the oil tank. Remove

and check the oil level.

Note: The oil level should be between the two oil

lines around the bottom of the dipstick as shown in

figure 4.

■ Replace oil drain bolt. Tighten securely.

■ Dispose old oil at an oil recycling center.

SHARPENING THE WEDGE

After using the log splitter for some time, it may be

necessary to sharpen the wedge. Using a fine-toothed

file, smooth any burrs or crushed areas along the

cutting edge.

English

E I P NL FIN GR TR

ELS-52_9 lgs 12/3/01 2:36 PM Page 18

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 96 97

Commentaires sur ces manuels

Pas de commentaire

Ryobi ELS-52 Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Séparateurs de bûches Ryobi ELS-52