Ryobi ELS-52 Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 97
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
19
GB
F
English
E I P NL FIN GR TR
Motor fails to start
Won’t split logs
Log mover jerks and
vibrates
Oil leaks around cylinder
ram or from other points
1. Overload Protection Device is
disengaged to protect the log
splitter from being damaged.
1. Log is improperly positioned.
2. The size or hardness of the log
exceeds the machine’s capacity.
3. Wedge cutting edge is blunt.
4. Oil leaks.
5. Unauthorized adjustment was
made on the Maximum Pressure
Limiting Screw. Lower maximum
pressure rating was set.
1. Lack of hydraulic oil and
excessive air in the hydraulic
system.
1. Air sealed in hydraulic system
while operating.
2. Bleed screw is not tightened
before moving the log splitter.
3. Oil drain bolt is not tight.
4. Hydraulic control valve assembly
and/or seal(s) are worn.
1. Push reset button (15). See fig. 13.
1. Refer to Operation section for log loading.
2. Reduce the log size before splitting.
3. Refer to “Sharpening Wedge” in the
Maintenance section.
4. Locate leak(s). Contact the dealer.
5. Contact the dealer.
1. Check oil level for possible oil refilling.
Contact the dealer.
1. Loosen bleed screw by 3-4 rotations
before operating the log splitter.
2. Tighten the bleed screw before moving
the log splitter.
3. Tighten the oil drain bolt.
4. Contact the dealer.
ELS-52_9 lgs 12/3/01 2:36 PM Page 19
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 96 97

Commentaires sur ces manuels

Pas de commentaire