Ryobi RY15550 Manuel de l'opérateur télécharger pdf (Page 9)

7 — English

ASSEMBLY

The attachment connects to the power head by means of

a coupler device.

 Stop the motor and remove the battery pack.

 Loosen the knob on the coupler of the power head shaft

and remove the end cap from the attachment.

 Push in the button located on the attachment shaft. Align

the button with the guide recess on the power head coupler

and slide the two shafts together. Rotate the attachment

shaft until the button locks into the positioning hole.

NOTE: If the button does not release completely in the

positioning hole, the shafts are not locked into place.

Slightly rotate from side to side until the button is locked

into place.

 Tighten the knob securely.

WARNING:

Be certain the knob is fully tightened before operating

equipment; check it periodically for tightness during use

to avoid serious personal injury.

REMOVING THE ATTACHMENT FROM THE

POWER HEAD

 Stop the motor and remove the battery pack.

 Loosen the knob.

 Push in the button and twist the shafts to remove and

separate ends.

ATTACHING THE FRONT HANDLE

See Figure 3.

 Loosen and remove the wing bolt and washer from the

handle.

 Install the handle on the power head shaft in the area

indicated by the illustration.

 Adjust handle up or down, if necessary, to desired

operating position.

 Reinstall the washer and wing bolt. Tighten wing bolt to

secure.

INSTALLING AN ATTACHMENT TO THE POWER

HEAD

See Figure 2.

WARNING:

Read and understand entire Operator’s Manual for each

optional attachment used on this power head and follow

all warnings and instructions. Failure to follow all instruc-

tions could result in electric shock, fire and/or serious

personal injury.

WARNING:

This 40 V power head is designed to be used only with the

attachment models that are specified in this Operator’s

Manual. It is not designed to be used with brush cutters

or other attachment models. Use of other attachments

could cause serious personal injuries or property damage.

WARNING:

Never install, remove, or adjust any attachment while

power head is running. Failure to stop the motor can

cause serious personal injury. Never operate power head

without an attachment.

This 40 V power head may be used with only the following

Ryobi Expand-It attachments:

 RY15518 Edger

 RY15519 Blower

 RY15523 and RY15523A Straight Shaft String Trimmer

 RY15525 Curved Shaft String Trimmer

 RY15550 Cultivator

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY15550 Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Ryobi RY15550