Ryobi RY15550 Manuel de l'opérateur télécharger pdf (Page 13)

9 — English

LOCK-OUT BUTTON

See Figure 6.

The lock-out button reduces the possibility of accidental

starting. The lock-out button is located on the handle above

the switch trigger. The lock-out button must be depressed

before you pull the switch trigger. The lock resets each time

the trigger is released.

STARTING AND STOPPING THE POWER HEAD

See Figure 6.

 To start the power head: Depress the lock-out button and

squeeze the switch trigger.

 To stop the power head: Release the switch trigger.

OPERATING THE POWER HEAD

See Figures 7 - 13.

WARNING:

Motor housing may become hot during operation. Do not

rest or place your arm, hand, or any body part against

the motor housing during operation. Only hold the unit

as shown in figures 7 - 13 (depending on attachment

used) during trimmer operation with all body parts clear of

motor housing (or as shown in the applicable attachment

Operator’s Manual). Extended contact with the motor

housing may result in burns or other injuries.

WARNING:

Always position the unit on the operator’s right side. The

use of the unit on the operator’s left side will expose the

user to hot surfaces and can result in possible burn injury.

WARNING:

To avoid burns from hot surfaces, never operate unit with

the bottom of the motor above waist level.

Hold the power head with your right hand on the rear handle

and your left hand on the front handle. Keep a firm grip with

both hands while in operation. Power head should be held at

a comfortable position with the rear handle about hip height.

Always operate power head at full throttle. If debris becomes

wrapped around the attachment, RELEASE THE SWITCH

TRIGGER, unplug the unit, and remove the debris.

WARNING:

Read and understand entire Operator’s Manual for each

optional attachment used on this power head and fol-

low all warnings and instructions. Failure to follow all

instructions may result in electric shock, fire and/or seri-

ous personal injury.

WARNING:

Do not allow familiarity with product to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked

to comply with ANSI Z87.1. Hearing and/or head

protection may also be required depending on the type

of attachment used and as prescribed in the attachment’s

Operator’s Manual. Failure to do so could result in objects

being thrown into your eyes and other possible serious

injuries.

WARNING:

Do not use any attachments or accessories not recom-

mended by the manufacturer of this product. The use of

attachments or accessories not recommended can result

in serious personal injury.

CONNECTING TO POWER SUPPLY

See Figure 4 -5.

The power head is designed with a cord retainer that pre-

vents the extension cord from being pulled loose while using.

 Form a loop with the end of the extension cord.

 Insert loop portion of extension cord through opening in

the bottom of the rear handle and place over cord retainer.

 Slowly pull loop against cord retainer until the slack is

removed.

 Plug power head into extension cord.

NOTE: Failure to remove all excess cord slack from extension

cord retainer could result in plug loosening from receptacle.

OPERATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY15550 Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Ryobi RY15550