Ryobi RY15550 Manuel du propriétaire télécharger pdf (Page 11)

ASSEMBLY

This electric power head may be used with only the following Greenworks, and Ryobi Expand-it

attachments.

GW 29402 Straight Shaft String Trimmer, 29017 Hedge Trimmer, 29027 Pole Saw,

29047 Tiller, 29057 brush Cutter, 29067 Blower

RY15518 Edger RY15520 Pruner RY15523 Straight Shaft String Trimmer RY15525 Curved

Shaft String Trimmer RY15550 Tiller RY15519 Blower

NOTE: When using string trimmer attachments, use only .080 in. diameter line.

The attachment connects to the power head by means of a coupler device.

• Unplug the power head.

• Loosen the knob on the coupler and remove the hanger cap from the attachment.

• Push in the button located on the attachment shaft. Align the button with the guide recess on

the power head coupler and slide the two shafts together. Rotate the attachment shaft until the

button locks into the positioning hole.

NOTE: If the button does not release completely in the positioning hole, the shafts are not locked

into place. Slightly rotate from side to side until the button is locked into place.

• Tighten the knob securely.

W A R N I N G

Be certain the knob is fully tightened before operating equipment; check it periodically for

tightness during use to avoid serious personal injury.

ATTACHING THE FRONT HANDLE(See Figure 3.)

Fig.2

POWER HEAD SHAFT

POSITIONING HOLE

KNOB

ATTACHMENT SHAFT

BUTTON

Fig.3

FRONT HANDLE

BOLT WASHER

WING NUT

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Ryobi RY15550 Manuel du propriétaire Page 11