Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 101)

Page 92 Power Equipment Usage Manual (Rev. 5/10)

18.2. Setup & Use – Pneumatic Air/Oil

Pneumatic tools need to receive a continuous supply of oil as

well as air. In the Woodshop, that supply comes by routing the

compressed air coming from the compressor through the black

automatic oiler shown in this picture.

The blue device in this picture regulates the air pressure and it

needs to be checked to make sure the pressure is set between

85-90 PSI before connecting the tool. There are several such

setups in the Woodshop.

The picture shows the pressurized air and automatic oiler system located by the sanding table.

18.3. Setup & Use – Brad Nailer

18.3.1. Preparing the Tool

a. Connect the tool to the air

supply (see Figure 1).

b. Depress latch and slide

magazine cover open (see

Figure 2).

c. Insert a strip of approved

fasteners (see Figure 3).

Orient fasteners with points

down, and in contact with the

bottom of the magazine.

d. Push magazine cover closed

(see Figure 4).

e. Adjust the directional exhaust

deflector (A), Figure 5, so that the exhaust air blast will be directed

away from the operator. Grasp the deflector and rotate it to the

desired position for the current application.

f. NOSE CUSHION: This tool is equipped with a rubber nose cushion (A),

Figure 6, that prevents marring of finished surfaces by the metal safety

during normal operation. The nose cushion can be removed and stored

in the rear area of the magazine (B) Figure 6, when it is not required.

CAUTION: Disconnect tool from air supply before removing or

reinstalling rubber nose cushion.

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 101