Ryobi DBJ50 Instructions d'exploitation Page 105

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 139
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 104
Page 96 Power Equipment Usage Manual (Rev. 5/10)
19.2.3. Assembling the Motor in the Router Base
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
a. Loosen the clamp screw (A) Figure 1 to allow the power unit to be set in the base unit.
b. Insert motor unit into base aligning lower pin (B) with groove in base.
c. Rotate motor unit CLOCKWISE into base until upper guide pins are rigidly set in the groove of
the base.
d. Tighten clamp screw firmly.
19.2.4. Adjusting Depth of Cut
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
a. Loosen clamp screw (A), Figure 3.
b. While holding base (E), turn motor unit (F), Figure
3, COUNTERCLOCKWISE until the tip of the bit is
above bottom surface of base.
c. Set router on flat wood surface.
d. Turn motor unit (F), Figure 3, CLOCKWISE until bit
touches the wood surface.
e. Tighten clamp screw (A), Figure 3.
f. Rotate depth adjusting ring (B), Figure 3, until the zero-line (C) is opposite the index line (D) on
the housing.
g. Loosen clamp screw (A), Figure 3.
h. Tip the router so bit is clear of the wood
surface. Turn motor unit (F), Figure 3
CLOCKWISE until the index line (D) on the
motor housing reaches the desired depth
indicated on the ring.
i. Tighten clamp screw (A), Figure 3 firmly.
NOTE: Setting the index line to 1/4" on the ring means
the cutting edge of the bit is exposed 1/4" below the
base.
Vue de la page 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 138 139

Commentaires sur ces manuels

Pas de commentaire