Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 106)

Page 97 Power Equipment Usage Manual (Rev. 5/10)

19.2.5. Adjusting Sub-base Alignment

Applications using a template guide require the bit to be centered within the guide. This, in turn,

requires the center hole in the sub-base to be in line with the collet of the motor unit. Your model has

an adjustable sub-base which has been aligned at the factory. If the sub-base has been removed and/or

readjustment is required, proceed as follows:

CAUTION: Be sure power switch is in “OFF” position and tool is disconnected from power source to

avoid accidental starting of motor which could result in personal injury.

a. Loosen sub-base mounting screws just enough to allow sub-base to move on base.

b. Loosen clamp screw (see Figure 4), and adjust motor so that the collet nut engages the center

hole in the sub-base. Allow the sub-base to center itself on the collet nut. Tighten clamp screw.

c. Tighten sub-base mounting screws securely

19.2.6. Installing Motor in Plunge Base

CAUTION: DISCONNECT TOOL FROM POWER SOURCE.

a. Support clamp (see Figure 5) and loosen motor clamp screw approximately 1/2", with Allen

wrench (furnished).

b. Insert motor unit

into base with

switch positioned at

front of left handle

(see rear view in

Figure 6), and align

the four pins (A)

Figure 6, in the

motor case with the

slots (B) Figure 6, in the base.

c. Seat motor in base and tighten clamp screw to secure.

19.2.7. Removing Motor from Plunge Base

CAUTION: DISCONNECT TOOL FROM POWER SOURCE

a. Remove clamp screw, flat washer, lock washer, and

clamp locking nut.

b. Insert Allen wrench (A) Figure 7, as shown, to contact

locking plate. Tap lightly to release and remove locking plate.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 106