Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 108)

Page 99 Power Equipment Usage Manual (Rev. 5/10)

Normally the deepest desired cut is set with the depth rod resting on the shortest turret stop (A)

Figure 11. The other two fixed stops then provide reduced cutting depths of 1/4" and 1/2"

respectively. The three adjustable stops may be adjusted to any desired height. Any

combination of fixed and/or adjustable stops may be utilized to achieve the desired depths

required for a particular job.

b. Release plunge mechanism by pulling the locking lever (B) Figure 9, to the left and lower plunge

mechanism until the router bit just touches the work surface. Release lever and push to the

right to lock mechanism in this position.

c. Tighten depth rod locking knob.

d. Position depth indicator (C) Figure 10, at “0” position and tighten knob.

e. Loosen depth rod

locking knob and raise

depth rod until

indicator aligns with

the graduation

representing the

desired depth of

plunge. (The example

in Figure 12 shows

setting for 1" plunge.)

f. Turn lower travel limiting nut until it is approximately 1/4" above the top of the plunge housing

(see Figure 13). While holding lower nut, turn upper nut until it “jambs” against the lower nut.

CAUTION: The travel limiting nuts must always be “jammed” together to prevent movement

(caused by vibration) which could prevent full bit retraction.

CAUTION: The travel limiting nuts must always be set so that bit can be retracted into base of

router, clear of work.

DO NOT attempt to increase plunge travel by readjusting the stop nut. Increasing the travel

beyond 2-1/2" can cause mechanism to jam.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 108